About dust. The content of coal ash and dust released from the chimney is quite low. Our factory does not exceed 22 mg under non-damage conditions. First of all, the electrostatic precipitator is pretty awesome. Secondly, the flue gas needs to be washed by the slurry sprayed by the slurry circulation pump in the desulfurization tower. In addition, they must be dehydrated by the demister. outside if you want. The white smoke you see in the chimney exhaust is actually water that condenses into the atmosphere after the smoke passes through the water! These blind journalists completely disregard the fruits of our desulfurization efforts, okay? ! Truly clean flue gases are grayish white and slightly transparent. It is unrealistic to see black smoke at the mouth of a power plant's chimney, because it means the coal is not being burned properly.ctment and will be evaluated! , Please forgive me. I once carried out the bypass desulfurization operation and had the opportunity to see the appearance of clean combustion gases entering the atmosphere, that is, you can't see anything discharged from the chimney, so what you can't see is the. the most frightening. Finally, the dust melted in the slurry enters the dewatering system with the slurry and turns into gypsum, which is made into soft pieces.
No electricity consumption
There are two types of wastewater (hot) in power plants: one is circulating industrial water (absolutely not used for bathing); there is also waste water discharged from boilers (which contains various dirt and is not suitable for bathing). If it is condensed water, it will be reused in the boiler (usually recovered in the turbine condenser). A Ther good water will not be wasted.
It is perfectly possible to use the residual heat steam to heat the bath water. Current thermal power plants use this model to obtain social benefits.
The waste hot water produced by thermal power plants is. generally it is boiler steam condensate water, which should be considered distilled water of lower purity. It doesn't seem logical that there is a problem. This type of thermal energy recovery is widely used to produce hot water in public baths.