Coolant is very low.
If the car owner does not check, uncover and add coolant in time, it will easily cause the engine to overheat. According to the car owner: the engine will be very hot after driving. some time, and it should not stop. This is a lack of coolant problem. It is most likely caused by a leak in the water tank pipe and a serious lack of coolant.
Precautions for car generators
A belt that is too loose on the generator will easily slip, causing the generator to undercharge the battery, resulting in power loss of the battery and, in serious cases, the battery may lose power. The amount of energy cannot start the engine. Consequently, the tightness of the beltThe generator must be checked and replaced from time to time. The replacement cycle of belts is about 60,000 to 80,000 kilometers, and a small number of belts can be replaced between 80,000 and 100,000 kilometers.
If the battery status observation hole is always black, it means that the battery power has been insufficient for a long time. It is likely that there is a problem with the generator and it has not been able to charge efficiently. battery. At this point, the generator should be checked to avoid complete breakdown. It is normal for the battery viewing hole to appear green.
What is the reason for the high temperature during operation of the silent diesel generator?
Cause 1: Long-term overload operation leads to increased consumption fuel, an internal increase Heat dissipation and boiling of antifreeze liquid and other phenoleads. Solution: The best solution in this situation is to avoid overloading for long periods of time. If the machine is going to run for a long time, it is best to let it rest for 10 minutes every three or four hours! Please cool before use! Reason 2: It is very important that the coolant inside the engine reaches the standard. Usually, insufficient antifreeze will reduce the heat dissipation effect of the equipment and cause the unit to overheat. Solution: Considering the high temperature in this situation, the operator should check whether the fuel tank is filled with coolant before starting the machine in daily use, so that it can be filled in time. There are many causes of high engine temperatures, but problems with pumps, thermostats, fans, and water tanks are almost all of them.always the cause. To avoid further losses, it is not recommended to continue mining. Please call the manufacturer or 4S store directly for assistance. Reasons for high engine temperature: 1. Engine overheating problem not only occurs in summer, but also may occur during daily driving, and the engine should be checked regularly. 2. If the vehicle has a high temperature, the first consideration may be a failure of the vehicle's cooling system. The cooling system is generally composed of water pumps, water tanks, cooling fans, thermostats and other components. Failure of any of these components can cause high temperatures. 3. High temperatures will also occur when the vehicle is overloaded in case of engine operating heat. cannot be processed in time, a strike will occur. VS'is normal. This phenomenon can occur even if the vehicle's fuel tank and antifreeze bottle are damaged, which is also worth noting.
If the temperature of the silent diesel generator is too high, it will reduce the corresponding clearance of moving parts, reduce resistance and cause poor lubrication. In severe cases, this can cause pulling of the cylinder and shaft. holding accidents. Therefore, when the temperature of the diesel engine is too high, it should be repaired in time. The main causes of generator set excessive temperature are: (YANAN) Diesel Generator Response: 4000-080-999)
1. Delaying fuel delivery too late will cause the diesel engine to overheat.
2. The silent diesel generator uses hard water for a long time, and a large amount of scale is formed in the water tank and waterways, resulting ine poor heat dissipation.
3. Insufficient cooling water causes the diesel engine to overheat.
4. Yanan Generator Tips: Burns engine oil seriously, causing excessive carbon deposits and poor heat dissipation.
5. There are too many impurities deposited in the water channels between the body and the cylinder head, causing water circulation to be blocked and heat dissipation to be poor.
6. Put it into operation at full load immediately after repair, causing overheating or jamming of moving parts due to too little mounting clearance.