Let me answer your question: The flow rate of a water pump usually has several important parameters, including head and flow rate per unit time. The water pump is driven by a motor assuming the rated power output of the motor is equal. to the rated output power of the water pump, then only when the water pump is at full load, the motor is at full load and the current can reach the rated current level. Your water pump is not operating at full load and the motor has not reached its rated current. Generally speaking, what is called full load indicates whether the water flowing through the unit reaches the rated value. This is related to frequency, but it does not mean that the frequency is the rated value, which means full load. it also depends on how much water the pump can pump. The more water it pumps, the higher the current can be. also seenble from the outlet pressure.
What is peak regulation and frequency modulation
Yes.
The basic principle of the Buffalo generator system is to use the vehicle engine as the drive source to drive the three-phase generator. Because the engine speed of the vehicle is not fixed, the frequency and the engine are not fixed. output voltage by the three-phase generator None of them can be used directly by users, so a high-frequency digital electronic system is used to integrate the three-phase power generated by the generator and transmit it to users in the form of 50 Hz. 240V mains supply.
Buffalo is a mobile power system, with the Buffalo system. Get power no matter where your vehicle goes.
Means of peak shaving in the electricity network
As it is relatively simple to start a ghydroelectric generator, the hydroelectric peak shaving method is currently widely used. Additionally, pumped storage units can be used; used to pump water during low valleys Valley filling, electricity generation and peak shaving during peak hours, i.e. when the load is in the low valleys, the pump is an electrical device which converts electrical energy into potential energy of water and temporarily stores it; once electricity consumption reaches its maximum, this part of the water is transformed into electrical energy and injected into the network. In short, all these measures start from the postulate that the total installed power is greater than the peak load and adjust the operation of the production units.
Frequency regulation of the power system
China's power system is our power grid. Its electrical frequency isof 50 Hz, what we usually call the electrical frequency. This frequency is the time it takes. the power to travel in a positive cycle. Determined, f = np/60 where f is the frequency, and n is the rotation speed of the generator. For the turbogenerator, which is a high-speed engine, it is 3000 rpm, p is the number of pole pairs of the engine, and the turbine-alternator is a hidden pole. Formula, the thermal power plant has a pair of stages and the steam turbine of the nuclear power plant has 2 pairs of stages. our power frequency is 50 Hz. The state stipulates that within this 50 Hz range, the positive and negative deviation does not exceed 0.2 Hz. Small systems can rightly be considered positive and negative of 0.5 Hz. is 60 Hz, which is not much different, but the power quality is slightly better.