Below the minimum liquid level line. The remaining amount of antifreeze in the generator must be maintained above the minimum liquid level to ensure normal operation of the generator in low temperature environments and to avoid frost cracking or other damage. Therefore, the remaining amount of antifreeze in the diesel generator is below the minimum level. minimum fluid level. Antifreeze is a liquid used to prevent engines from freezing and cracking. It is usually mixed with water and antifreeze. The function of antifreeze is to lower the freezing point and boiling point of water to ensure normal engine operation in low or high temperature environments. .
What should I do if the coolant level is low?
The water level switch is used in the water tank or water tank generator coolingtor, of the engine, mainly to measure the engine. Cooling water level and positive water level. The switch has a water level alarm function, which can be set to high or low level alarm, depending on the actual situation. It also has a delayed alarm function and the alarm information can be sent to external devices.
Why does the car alarm light come on?
1: First of all, observe if there is a leak.
2: Observe if there is a leak at the motor seal.
Then add antifreeze, and finally use the same brand.
1. Check if the water tank cover is secure.
2. Try filling the water tank with air to see where the water in the tank escapes when pressurized, then decide on a repair plan.
3. Unscrew the engine oil cap and check for signs of oil emulsification (phphenomenon of punching or corrosion). If so, disassemble the engine and replace the cylinder gasket.
4. There are problems with the quality of the water tank.
If the water pipe of the water tank breaks and leaks due to vehicle vibration or vehicle accident while driving the car, measures can be taken according to the specific situation:
The leak should not exceed 1mm crack or if there is a 2mm hole, add a bottle of strong anti-leakage agent for water tank into the water tank and start the car.
Five to 10 minutes after turning on the cooling water and starting a large circulation, water leak (or antifreeze) in the cooling system, whether it is the cooling tank Water, rubber hose or pads everywhere, will stop leaking. Once the leak is stopped, there is no need to release it without affecting heat dissipation or sealingage.
If there is a slight leak in some heat dissipation pipes while there is no anti-leakage agent to carry, you can temporarily put shredded tobacco into the heat dissipation tank. water and use the water circulation pressure to block the leakage of the heat dissipation pipe for temporary use.
In case of serious water leakage from the water tank radiator hose, you can cut the leaking radiator hose from the leak point, block the cut radiator hose with a ball cotton wool coated with soap, then use pliers to remove the cut radiator hose. Tighten the head flat, then tighten it firmly to prevent leaking.
If the rubber pipe joint is leaking, you can use a screwdriver to wrap the rubber pipe joint clip twice on the rubber pipe joint in time, and then tighten it with pliers. If the rubber tube is damaged, you canUse tape to wrap the broken area tightly for temporary use.
A car's warning light indicates a problem with one of the car's systems. For example, an oil pressure warning light indicates that the engine oil pressure or level is low. When the water temperature light is on, it means the coolant temperature is too high or the coolant level is too low. When the battery indicator light is on, it means the battery voltage is low and the engine is running.Insufficient or no power generation; If the check engine light comes on, it may be a mechanical fault or a circuit fault, and immediate action is necessary.
System fault indicator light, when the parking brake is applied, the indicator light changes to **; If the light turns red while driving, it meansBeware that the brake fluid level in the reservoir is too low or that the brake There is a problem with the device. Check as soon as possible.
Low oil pressure warning light. If the light is on, it is likely that the oil pressure is too low and you cannot continue driving. Please stop the engine and check the engine oil level. If you find that the engine oil level is normal but the light is still on or flashing, you should not start the engine in a hurry, otherwise the engine will be damaged.
Brake system failure warning light. When the light is on, it is likely that the brake system is faulty and the brake system fluid level is too low. At this point, you should drive at low speed, brake in advance and increase the pedal force.
The safety system warning light comes on when the pre-collision system is activated. The pre-collision systemcan issue a collision warning to the driver before a collision, prepare emergency braking when the car is in danger, assist the driver in braking, and activate automatic braking.
Generator Fault Indicator When the indicator is on, the generator may be malfunctioning. When the ignition switch is turned on, the alternator fault light turns on for a self-test and turns off automatically after a few seconds.
One million subsidies for car purchases