Add a solar water supply valve to connect to an electric water heater, and the pipes do not need to be modified, thus realizing this idea.
Connect one end to the solar water supply valve, one end to the water heater, then install a copper valve When using solar power, simply close the valve by copper installed if desired. want to use the water heater, open it. This copper valve will do the trick.
If your bathroom's electrical wiring can handle 3,000W, install an instant-heat showerhead. It costs less and is easy to install. Simply remove the shower head and connect the hose to the instant electric heater. Showerhead. Shower head type, do not plug in the instant heater when the solar water is hot, plug in the instant heater when the solar water is not hot.
IIt is better to buy an instantaneous electric water heater, because if the capacity of the electric water heater is too large, you will have to heat cold water every day, take a bath, and then put down the hot water at all, that is, the capacity of thermal electric water heaters is relatively small. If the solar water outlet pipe is directly connected to the water inlet pipe of the electric water heater, insufficient water pressure may easily occur. solar energy and instantaneous electric water heaters, distributed in two bathrooms.
How to replace the solar water inlet silicone ring?
Water can be supplied by opening the water supply valve using solar energy. Tap water passes through the upper and lower water pipes and begins to replenish solar energy. When the water is full, it will automatically stop. When we use water, close the water valvewater supply and open the water switch or water mixer.
There are three valves in the water supply system of the solar water heater. One is the tap water switching valve, the second is the water injection valve for the solar water heater, and the third is the after water outlet valve. The water is full. When water is to be supplied, the tap water must first be turned on. switch, then open the water supply valve and drain valve. When the water is full, the buzzer will sound an alarm. Normally, the drain and tap water switches can be normally opened, so in actual use, only one water supply valve is needed.
Detailed information
Solar water heaters convert solar energy into thermal energy and heat water from low temperature to high temperature to meet the needs of people in life and producthot water action. Solar water heaters are divided into vacuum tube solar water heaters and flat plate solar water heaters based on their structural shapes. Evacuated tube solar water heaters are the main ones, accounting for 95% of the domestic market share.
Home evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related accessories. The conversion of solar energy into thermal energy mainly relies on heat collecting tubes. The heat collecting tube uses the principle of hot water floating up and cold water flowing down to cause microcirculation of water to achieve the required hot water.
When the vacuum tube water heater absorbs heat, the solar radiation passes through the outer tube of the vacuum tube, is absorbed by the heat collecting coating, and then transtransferred to the water in the tube along the wall of the inner tube. . After the water in the tube absorbs heat, its temperature increases and its density decreases and increases, forming an upward force and forming a thermosyphon system. As the hot water continues to rise and be stored in the upper part of the water storage tank, at the same time the lower temperature water is continuously replenished on the other side of the pipe and so Afterwards, the entire tank is filled. the water rises to a certain temperature.
Flat plate water heaters are generally split type water heaters. The fluid naturally circulates in the heat collecting plate due to the thermal siphon, and the heat radiated by solar radiation on the heat collecting plate is transferred to the water tank in time. The water tank passes through a heat exchanger (jacket or coil) which transfers heat to the'Cold water. Fluid can also flow through the pump to achieve heat transfer.
The specific method is as follows:
1. First turn the water tank (in the direction of the exhaust hole towards the back). the fixing screws of your solar water tank are rusty. First, loosen it with a few hammers. If there is no rust, use a wrench to loosen it.
2. Then slowly remove the vacuum tube while rotating it, let the water out, then find a child (you have no choice but to find a child because you are not a professional). little hands can insert and seal it. The ring is blocked.
3. Apply detergent to the vacuum tube, rotate it and reinsert it. Reset the water tank and finish.
Detailed information:
Solar water heater
Water solar Heating isa heater that converts solar energy into thermal energy and heats water from low temperature to high temperature to meet people's use of hot water in life and production.
Solar water heaters are divided into vacuum tube solar water heaters and flat panel solar water heaters based on their structural shapes. Evacuated tube solar water heaters are mainly used, accounting for 95% of the domestic market share.
Home evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum tubes which use the principle that hot water is used. floats and cold water sinks, causing microcirculation of water to obtain the required hot water.
Reference :