The repair methods for leaking solar thermal insulation buckets are as follows:
1. If the inner tank of the water tank is damaged and causes water leakage. the side seams of the water tank, the inner tank cannot be repaired. The water tank can be replaced directly.
2. If the silicone ring or other accessories are damaged, causing leakage at the side seams of the water tank, the problem can be solved by directly replacing the accessories.
3. Repairing water leaks at the side seams of the bucket requires professional personnel to repair it.
4. Empty the water into the water tank and remove the vacuum tube. Remove the bucket from the holder and use a special tool to open the side cover of the water tank. Scrape the insulation under the outer shell to expose the inner pot. Re-solder the partdamaged inner tank, fill it with insulation material (special foaming agent is required) after cooling, cover the side cover and attach the water tank to the bracket. Insert the vacuum tube and you're done.
Causes of leaks in solar thermal insulation buckets
1. Leaking water pipes: If the water pipe is leaking or the water pipe is leaking, this is the case. because the PPR water pipe or aluminum-plastic pipe passes through Years of exposure to wind and sun will make it age. In this case, the solar hot water pipe needs to be replaced.
2. Solar Valve Leak: Valve leak means valve failure. In this case, a new solar valve or solenoid valve must be replaced.
3. Solar overflow pipe, exhaust pipe leak, cap leak: Leaks at the solar exhaust outlet are usually caused by damagedamage to the sensor or instrument. In this case, the water temperature and level meter must be replaced or replaced. new. Solar meter.
4. Solar heating pipe leaks: The solar heating pipe is leaking at the electric heating position, which means the electric heater is rusty and damaged and needs to be replaced with a new sealing ring or electric heating rod .
5. Water leakage from solar vacuum tube: Water leakage from solar vacuum tube is mainly caused by the aging of the solar silicone ring. The vacuum tube should be disconnected and replaced with a new silicone ring. .
Repair methods for solar lights that do not light: replace the bulb, replace the battery, convert the positive and negative poles of the battery and connect the circuit. .
1. Change the bulb: Check the bulb to see if itIt can light up. If the bulb does not light up, it is probably broken, so choose to replace it. bulb.
2. Replace the battery: The solar battery is broken or the voltage is not enough. It is recommended to replace the battery with one with comparable voltage and see if the solar light can light up.
3. Battery positive and negative pole conversion: If the positive and negative poles of the battery are connected backwards, it is recommended to remove the battery and install the positive and negative poles correctly to see. if the solar light can light up.
4. Connect the circuit: There may be some reasons why the circuit is broken and loose. You can use tape to reconnect the circuit. Make sure to wrap it well to prevent a similar situation from happening again.
Reasons why the solar light does not turn on
1 Damage to the bulb: The solar light does not turn on, flickers or turns on and. extinct. This may be caused by the blister. The reason is that the bulb may be broken naturally, and it may be man-made damage.
2. Battery damage: If the battery is not overcharged under normal circumstances, you can use a universal tester to test the voltage. Usually the voltage is 12V, and it generally will not exceed 12V. exceeds 12V, it gives When charging the battery, if it is lower than 12V, there is no way to charge it. Battery voltage can be used to determine if solar is working or if it has worked sufficiently. time, and therefore whether the solar light is on or not.
3. Are the positive and negative poles of the battery connected in reverse? The solar light turns on for a moment when it is first installed, then turns off and does notnever lights up again. This is probably solar energy. The positive and negative poles of the light battery are reversed.
4. Check the line: Finally, it is recommended to check the line to see if the line is broken, or if the connector is loose, and if there is any wear.