Do you want to ask: The reasons why the solar sealing rubber ring is unstable are as follows:
1. The quality of the rubber ring itself. If the quality of the rubber ring is not good, it will deform, become soft or lose elasticity, causing the solar panel to fail to hold or become unstable.
2. The installation is not in place. If the rubber sealing ring is not installed in place or is not completely compacted when installing the solar panel, the rubber ring will also become stuck or unstable.
3. Incomplete cleaning. If the installation location is not cleaned when installing the solar panels, impurities or dirt will appear, causing the rubber ring to not completely fit the installation location and will get stuck.
The installation and removal methods of solar tubes are as follows:ntes:
Tools/Materials: SANGGAOXSY-24 solar water heater, gloves, soap plate.
1. First, drain the water from the solar water heater pipe.
2. Then wear gloves and buckle the rubber ring at the connection between the vacuum tube and the water tank.
3. Buckle the rubber ring and the tube can be removed.
4. When installing, you should first apply a little dishwashing liquid to the installation part of the pipe to lubricate the installation.
5. Then aim for the hole at the top of the water, gently rotate and push up.
6. Push it forward about 15 centimeters, aim at the bottom, rotate it slightly and remove it.
7. Slowly put it into the bottom, as shown in the picture below, the installation is successful.