Don't catch that. In addition to what the previous brother said, it is also important that your solar energy is not a brand. The brand is definitely 304 stainless steel. There will never be any problem of water tank leaking. . If there is, it is also covered under warranty. If it is not a solar brand, the base water tank is not 304 stainless steel. It is rotten and rusty. You can't fix it. and I fixed it. After repairing it, the edge cracked or there was a hole. Mainly what I'm talking about is that the barrel body isn't necessary, but there is a place you can open and take. look first, these are the two ends (it's not rotten and rusty, it's the kind where the interface is cracked.) This area is leaking. Maybe it can be fixed, although if it is fixed you'll have to ask. someone to help you. Bring a small slot machineuder at home. If you dismantle and install solar, the labor cost is too high and it is not cost-effective. A small welding machine can weld directly on the roof. , that means welding in a circle, otherwise it will be welded on the side. It cracked)
Besides, if it's not a brand, it's better to buy a new brand once and for all
1. When installing, please first look at the water tank collector tube (the vacuum tube socket - the vacuum tube hole. The stainless steel edge of the vacuum tube hole is smaller than the hole in the insulation layer.
2. Hold the silicone ring and look at the edge on the side. There is a groove in the middle of the silicone ring, one side should be more. thick and the outer circle larger and the other side should be thinner and smaller The side with the thinner side and the smaller outer circle faces inward when p.laced at the water tank suction pipe hole. The groove should be completely closed with the stainless steel hole visible at the mouth of the water tank suction pipe.
3. When installing, first install one side little by little. It's like installing a bicycle tire.
4. The installed silicone ring should look like the silicone ring in your hand, then the silicone ring is installed.
5. Then it's time to intubate. When intubating, first wet the windshield (usually a black rubber ring between the vacuum tube and the outer wall of the water tank) with clean water and put it on. the vacuum tube. The upper open end. At the same time, wet the installed silicone ring with detergent water or add water to the solar panel to let the water flow out of the vacuum tube hole. At this time, hold the tail of the vacuum tube with one hand to protect the end of the taile and hold 1/3 of the vacuum tube with the other hand. Use uniform force and keep the direction of the force consistent with the coaxial line of the tube. mouth. Insert the vacuum tube into the vacuum tube hole of the water tank. You can insert an extra section, wait until the tail of the vacuum tube is aligned with the protector bracket, then remove it until the vacuum tube and protector are aligned. The bracket is firmly fixed, then place the windshield ring firmly against the outer wall of the water tank.
6. Fill the water tank with water and it will no longer leak. Congratulations on your success.