Attach a piece of cotton thread to the new joint. Do not tie it tightly. Connect the large loop of wire from one end to the other. Then use your fingers to insert the new seal into the water tank. a small stick to push the new seal and stretch the wire. Once the gasket is in place, cut the cotton thread, remove the cotton thread inside, apply dish soap to the 4-inch pipe, and slide the water hose into the pipe. water reservoir. Or add a circle of grooves on the solar silicone pad When you place it, first attach a small edge of the silicone pad with the inner tank of the water tank, then tighten it clockwise little by little of a watch. The steps are as follows:
1. Drain the water to avoid burns and water leaks
2. Remove the pipes and other objects outside the broken silicone ring. Prevent various materials from scratching youhands?
3. Buy a new one and install it
4. Fill the water and pay attention to the time
(1) Silicone pad features:
1. High reliability
2. High compressibility, soft and elastic
3. Low thermal conductivity
>4, Natural adhesion, no need for additional surface adhesive
5. Meets ROHS, SGS and UL certification environmental requirements
6. Multiple color options, bright colors, customizable shapes. .
7. The raw materials are 100% environmentally friendly food grade silica gel.
8. Low carbon and environmentally friendly, non-toxic and odorless, soft, non-slip, shockproof, waterproof, heat insulating, not easy to age, not easy to fade and easy to fade. to clean.
9. Durable and effectively protects the furniture surface from burns and scratches.
10. Temperature resistance rangetemperature: -40 ~ 230 degrees Celsius. It remains soft and does not deform even when cooked or frozen.
11. Some silicone tampons must meet the US FDA food grade testing standard: 21CFR177.2600.
(2) Objective:
1. Filling between the circuit board and the heat sink
2. Filling between the integrated circuit and the heat sink or product shell
3. Filling between IC and similar heat dissipation materials (such as metal shields)
4. As a buffer for machine connections in industry, it is friction-resistant and sealed.
(Source: Baidu Encyclopedia: Silicone Mat)
How to replace the silicone ring of the solar water heater
The silicone The ring may be broken, there is a rubber ring called silicone ring at the junction of the solar vacuum tube and the water tank, which is used for sealing and hashigh temperature resistance. Must be replaced.
1. When installing, first look at the socket of the water tank collector tube (vacuum tube) - the stainless steel edge of the vacuum tube hole is smaller than the hole in the insulation. layer.
2. Hold the silicone ring and look at the edge to the side. There is a groove in the middle of the silicone ring, one side should be thicker and the outer circle should be larger. and the other side should be thinner and smaller. The side with the thinner side and smaller outer circle faces inward when placed at the water tank suction pipe hole. The groove should be completely closed with the stainless steel hole visible at the mouth of the water tank suction pipe.
3. When installing, first install one side little by little. Just like installing a bicycle casing, the tires are average.
4. The silicon ringne installed should look like the silicone ring in your hand, then the silicone ring is installed.
5. Then it's time to intubate. When intubating, first wet the windshield (usually a black rubber ring between the vacuum tube and the outer wall of the water tank) with clean water and put it on. the vacuum tube. The upper open end.
Push the solar tube up to separate the bottom from the base, then pull it down to remove it. Be careful not to damage the lower part like a small column of glass in a thermos. bottle, otherwise it will not work isolated. Remove the silicone ring and replace it, press it in the opposite direction and you will be fine. When installing, apply a little soapy water to the glass column, it will be more convenient.