1. The dust on the solar water heater is too thick and the solar water heater has been used for a long time. Many people do not pay much attention to cleaning and inspection work. Therefore, a lot of dust accumulates on the solar heat absorbing tube, which affects the absorption of solar energy by the heat absorbing tube, thereby preventing solar energy from producing hot water.
2. The solar vacuum tube is damaged. Vacuum tube is a very important part of solar energy. It has a certain relationship with the absorption of heat sources. If it is broken, it will also cause damage. sun so as not to produce heat.
water.
3. Solar sewer pipes, valves and joints leak, requiring specialized maintenance personnel to detect and repair them.
4. The tap water pressure is too high. In water heatersolar, the tap water pressure is too high, preventing hot water from flowing. The flow of tap water should be reduced. Balance the water pressure and hot water will come out.
5. Water leaks occur in solar water heaters. When installing solar water heaters, there are many pipes and water leakage is easy to occur, so it is necessary to install an independent valve.
5. p>and close it With a good valve, the solar water heater can avoid not producing hot water.
What is the reason why solar energy cannot be put into water?
The reasons are:
Solar energy is not injected into the water. Pipes and joints are leaking, preventing hot water from flowing. Or the tap water pressure is too high, preventing hot water from coming out and the tap water needs to be turned down. OrThe solar water heater may leak water, preventing hot water from flowing.
First: The solar sewer pipe is frozen.
Two: Maybe the water line is blocked.
The water coming out of the solar water heater is not hot
Reason: There is a lot of dust deposited on the surface of the vacuum collector tube and the plate reflective or there are obstructions; the vacuum collector tube leaks and loses vacuum; the heat pipe fails, the weather is not good, the solar radiation energy is insufficient, the water valve is not closed tightly, and the water fills or flows slowly; .
Solution: Take the following measures according to the above reasons: wipe off the dust on the surface of the vacuum collector tube and reflector, remove the obstruction; replace the vacuum collection tube; replace the heat pipe; use an electric auxiliary heater; to squeeze. Make the valve watertight orcheck the quality of the valve and replace the water valve parts.