The method of replacing the solar water outlet sealing ring is as follows:
1. Drain the water into the water storage tank, remove the vacuum collection tube. , and put your hand into the hole inside, pinch the edge of the old gasket and pull it inward to remove it.
2. Then align the groove of the new seal ring with the stainless steel hole in the hole and place it, with the large side of the seal ring facing outward and the small side facing inward.
Precautions for using solar energy
To do a complete inspection, first check whether the pipes are disconnected, leaking, cracked, etc., and at the same time, favor Protect with good quality insulation or anti-freeze devices. If there is a heating tape when installing, the pipe heating tape will automatically heat thepipe depending on the outside temperature. When the temperature reaches a certain temperature, the heating tape will automatically cut off the power, which can effectively protect the pipeline and prevent. frozen.
Determine the amount of water added based on how cold the weather is. If the outside temperature is above 0℃, you can consider adding water that night; if the outside temperature is below 0℃, it is better. add water the next morning to prevent the water outlet from opening. At the same time, in rainy and snowy weather, the amount of water in the solar water heater should be reduced appropriately. In cold weather, you can choose to open the hot water faucet of the solar water heater and let it drip slowly to ensure the smooth flow of water into the solar water heater. It is also the most effective way to prevent solar water heater pipes. gel.
Installation method of solar outlet pipe sealing ring
Replace 16 to 16mm. The method is as follows:
1. Remove the water inlet hose by turning it counterclockwise, remove the original water inlet hose, remove and install the new water inlet hose.
2. When replacing the sealing ring, you should choose the sealing ring corresponding to the diameter of the vacuum tube. There are three common sizes available: 16mm, 32mm and 64mm.
3. After the replacement is completed, you need to use a wrench to tighten it clockwise.
The installation method is as follows:
1. First, loosen the joints of the hot and cold water pipes of the solar water heater and remove the original sealing ring.
2. Use detergent and a clean cloth to wipe and clean the outlet pipe and interface as well as the new sealing ring.
3. Place the new sealing ring between the outlet pipe and the interface, making sure it completely covers and fits the interface.
4. Reconnect the hot and cold water pipe joints and tighten until the sealing ring is compressed and completely secured in place.
5. Finally, open the faucet of the solar water heater or turn on the water heater to check if the water flow is normal. If there is a leak or water leak, deal with it in time. .