1. Gas Boiler: Gas boiler is a very common heating method for manufacturing plants. Its advantages such as simple operation and strong production capacity are deeply appreciated by users. Using gas boilers for heating will not produce pollutants, save energy, and is environmentally friendly and energy efficient.
2. Oil Boiler: The oil boiler is also a relatively common heating method. It can use fuel oil as fuel. Its production capacity is strong and can meet the heating needs of production plants. However, safety and environmental issues must be considered when operating and maintaining oil boilers.
3. Coal-fired boilers: Coal-fired boilers have a greater demand for coal, but their production capacity is relatively stable andcan meet the heating needs of production plants. Since burning coal emits a lot of pollutants, its use must be environmentally friendly to ensure that it does not pollute the environment.
4. Heat Pump: The heat pump uses air or water sources to collect thermal energy and deliver it to a room at a constant temperature. It has significant effects in energy saving and environmental protection and is widely recognized by production users. plants.
5. Solar Water Heater: Solar water heater uses solar energy to collect thermal energy. It uses clean, environmentally friendly and low energy consumption, but the impact of factors such as dark clouds, snowy days and night is enabled. its heating must be considered.
Can we install solar modules on roof tiles?colored steel of the factory building
I don't know where you are from. Generally this requires a workshop of around 300 square meters plus foaming. a room of approximately 20 square meters and a cutting area of 100 square meters. It is best to have a warehouse of 200-300 square meters. Of course, a smaller warehouse is acceptable, depending on the throughput or level of automation you need. . These are data from a solar power plant in Harbin.
Solar modules can be installed on the colored steel tiles of the factory building. The notes are as follows:
1. The bottom of the colored steel tiles of the factory building is generally composed of steel purlins and steel roof trusses. When installing solar modules, the supports must be fixed on at least two steel purlins and form a fixed plane with transverse supports to ensure sufficient stability under the action ofs horizontal loads.
2. When installing solar modules, water supply and return pipes as well as signal lines passing through the roof must be waterproof. The roof cannot leak due to the solar energy installation.