It can be installed completely! You need to pay attention to some details here. Firstly, check whether the rubber ring at the solar water tank interface is damaged, you can replace it with a new one directly. rubber ring. I still have a few rubber rings here. Maybe you can use it if there is no obvious damage, you can install the solar water tank/bracket first, but do not tighten the four screws at the connection between the solar water. tank and the bracket, but you need to align the screw rods of the solar water tank with those of the bracket. Place the hole in place. At this point, use a dishwashing liquid commonly used at home to spread a circle around the mouth. of the vacuum tube to lubricate it. In this way, slowly screw it in like a light bulb. After inserting the solar vacuum tube into the water tank, it is too deep to install on the dollmobile. time, you just need to pull the vacuum tube towards the tailstock in the opposite direction. If there is a black dust ring on the vacuum tube, it is still recommended to install it. Otherwise, it doesn't matter much. I have a lot of these dust rings here. If you need them, you can call directly to request them and you will be responsible for the shipping costs. Of course, if you are a friend of Fuzhou, I will stop by. help. Also, don't break the vacuum tubes. I have vacuum tubes here, but the cost of taking them is very high, otherwise I will contact my local friends to help you. This is a very common installation method to install a heater -solar water with a pipe for upstream and downstream water. It's just that there is a problem with the automatic water shut-off component you installed. You can use a meter or install an additional return pipe. When the water is full, the water'flows from the return pipe and you can simply turn off the pipe. water supply. Depending on your needs, you can install an automatic water supply meter. It usually costs 300 yuan. A pipe for the rising and falling water of a solar water heater is a very common installation method. It's just that there is a problem with the automatic water shut-off component you installed. You can use a meter or install an additional return pipe. When the water is full, water will flow out of the return pipe. You can simply turn off the water. supply. According to your request, you can install a meter that automatically fills the water.
You can use a single pipe, but there are many hidden dangers. For example, water cannot be filled when sampling. a bath. If there are two pipes, the water will flow automatically when showering. When filling the eau, there is no need to fill the water manually. It should be noted that even if there are water inlet and outlet pipes, valves must be installed. be added to the two pipes near the water heater. Otherwise, any waterway inspections and renovations will require the entire solar water heater to be exposed.
Water supply: tap water valve. After opening the valve, the water flows into the water storage tank of the solar water heater due to pressure and is heated by the solar water heater when the water is filled. there is a pipe and water is overflowing. In this way, it can be determined that the water storage tank of the solar water heater is full, so the water tap of the tap for water supply is closed.
Water supply: Heated tap water is stored in the water heater storage tank. When the bathroom sprays or the hot water valve is opened, the water heatsude flows through the previous water pipe due to gravity and is discharged. made available to us.