What should I do if the solar water pressure is not high enough?

The main reasons for low solar water pressure are the following three aspects:

1. Ordinary solar water heaters are non-pressure products, and the hot water outlet pressure mainly depends on the size of the drop. If the distance between the solar water outlet and the place of use is small, the hot water flow will seem low when used. The pressure is less, especially for those who live on the top floor in the morning, they will obviously feel it when using it again. The solution is to appropriately increase the height of the solar power to increase the height difference, or use larger diameter upper and lower water pipes.

2. The pipeline is long and has bends, which hinders the flow of hot water. The solution is to rearrange the pipes.

3. If there is a blockage at the water inlet or outlet or upper water pipeseur and lower, the solution is for after-sales service personnel to come to the house for inspection.

The solar water heater is a device that uses sunlight to heat water. Solar water heaters are divided into vacuum tube solar water heaters and flat panel solar water heaters accounting for 95% of the domestic market share. Household vacuum tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum heat collector tubes. Pouring cold water to produce microcirculation in the water to reach the required hot water level.

What should I do if solar hot water production is too low?

The vertical gap between the solar water tank and the bathroom shower head is too small; trop of towers and thin pipes will also affect the hot water pressure if the horizontal pipe is too long, which will also consume; part of the water pressure; It is recommended to install the hose into the booster pump which is connected in parallel only for bathing, which solves the problem. Low water supply is likely caused by clogged pipes or blocked faucet filters. are non-pressure products, and the pressure of the hot water outlet mainly depends on the size of the drop. If the distance between the solar water outlet and the place of use is small, the hot water flow will seem low when used. The pressure is less, especially for those who live on the top floor in the morning, they will obviously feel it when using it again. Appropriately increase the height of solar power to increase the height difference, or use water pipesu upper and lower with thicker diameters; the pipes are long and have bends, which interfere with the flow of hot water, and rearrange the pipes if there are blockages; at the water inlet and outlet or upper and lower water pipes, you can ask professional after-sales service personnel to come to your house for maintenance.

The pressure of hot water from solar energy is very low. As a result, the water coming out of the shower head does not have much pressure and the water is very small (not all water pipes are blocked.) What is the reason? Solution

Cause analysis:

1. The vertical drop between the solar water tank and the bathroom shower head is too small;

2. the pipe has too many turns and this also affects the hot water pressure;

3. The hose is blocked or the faucet filter is blocked.

Solution:

1. Use a small pressure booster nozzle;

2. Change the mixer tap or add a thermostatic valve;

3. Rearrange the pipes;

4. Increase the height of the solar power appropriately to increase the height difference, or use upper and lower water pipes with larger diameters.

Daily maintenance of the solar water heater

1. When installing a solar water heater, there may be a smell of dust or oil in the water pipe. When using it for the first time, you can first open the faucet to remove debris.

2. The water stored in the solar water heater should be discharged regularly depending on local water quality conditions. Drain time can be selected in the morning when the sensor temperature is lower.

3. The surface of the solar water heater should be wiped regularly depending on the amount of dust in it.The area. It can be cleaned when it rains. Keeping the water heater surface clean can get higher heat. collection efficiency.

4. When hot water is not used for several consecutive sunny days, the hot water temperature will be very high. When using the solar water heater, please turn on the cold water first, then turn on the cold water. hot water to avoid burns.

5. There is usually a filter device at the outlet end of the faucet. Scale and debris in the water line accumulate on this screen. It should be removed and cleaned regularly to increase water flow. smooth exit.

6. In winter, it is very common for pipes to freeze. If it turns out that the pipe has frozen but is not yet cracked, it can usually be cleaned automatically after the temperature rises. You can also use a hair dryer to blow on the water pipe, orwrap a towel around the water line, then slowly pour it with lukewarm water. Do not cook it on fire, hit the water pipe, or scald it with boiling water, because. this will cause the pipe to burst. Multiple freeze blockages can easily cause pipes to freeze and crack. Pipe insulation measures must therefore be reinforced.

7. Solar water heaters should be cleaned, inspected and disinfected on average every two to three years. Users can also do some disinfection work themselves, such as purchasing chlorine-containing disinfectants and adding them. At the water. Pour it into your mouth, soak it for a while, and then release it, which can achieve a certain disinfectant effect.

8. Solar water heaters should be cleaned inside the vacuum tube every two to three years on average to prevent formation.n scale inside the vacuum tube and affect the heat absorption effect.

9. If the solar water heater is equipped with a special instrument, please pay attention to lightning and electricity protection. Do not take a shower and unplug the electric heater during thunder.

The pressure of hot water from solar energy is very low, so the water coming out of the shower head does not have much pressure because cold water is tap water, and the tap water pressure is high, so the water flow is large and the heat is high. The water flows by itself. If it is very small, there may be a blockage somewhere.

There are several solutions:

1. Replace it with an electric storage water heater, a gas water heater or a pressurized solar water heater, so that the water pressure is the same as tap water. Same thing in the pipeline.

2. Use a booster pump to increase water pressure.

3. Use a pressure shower.

Detailed information:

Advantages of solar water heaters:

2. Solar water heaters use solar energy to heat water. They are environmentally friendly and harmless and can work normally when there is sunshine.

3. Also, solar water heaters are very energy efficient and can save a lot of electricity compared to electric water heaters.

4. It is a high-tech product with large water production, good heat transfer and strong absorption capacity.heat generation.

5. Fully automatic static work, no noise pollution, no manual operation required.

6. Once the water is heated, it is drained and purified before being delivered to the user. It is clean and safe.

7. There is no risk of gas leakage, electricity leakage, poisoning, fire, etc., and it is highly safe.

8. Qualified quality solar water heaters can be used for more than ten years.