1. Typically, there are only two water pipes for solar water heaters. One is for cold water and hot water, and the second is an overflow pipe. The first must be connected to the indoor mixer. A general mixer has the functions of filling water and regulating hot and cold water. The second pipe is connected directly to the solar overflow port and placed next to the interior floor drain. The function of this pipe is to allow solar water to flow out of this pipe when it is full.
2. Hot and cold water pipe connection steps: first wrap the water inlet and outlet with raw tape, then install the pipe fittings and connect the special pipes for water heater installation solar, attach electric heating; stick firmly to the outer wall of the pipe and secure it with a sticky tie. Tighten; install the sensor into the water level hole on the water tank, then loosen the locking device, insert the metal sensor, insert it into the bottom of the water. tank and lock it to prevent movement and falling; then connect the tap water pipe to the installed water tank for the solar water heater; The last step is to connect the inner water pipe.
Solar water pipe connection diagram
1. Make sure the solar bucket has been installed and in the correct position, and the faucet or water outlet of the solar bucket has been connected. .
2. Find the water inlet and outlet of the washing machine. The water inlet is located at the top or side at the back of the washing machine and is marked with a water inlet mark. located at the bottom or side at the back of the washing machine and is marked with a water outlet mark.
3. Use a suitable connector or joint to connect the water outlet of the solar barrel to the water inlet of the washing machineer. Make sure the connection is tight and seal it with sealant tape or other sealing materials. avoid water leaks.
4. After making sure the connection is firm, open the faucet or water outlet of the solar bucket and check if there is water leakage, you need to recheck if the connection is correct. and make adjustments.
1. Firstly, you need to have the matching accessories, then follow the instructions in the picture above to put the nuts and coupons, then insert them into the water pipe.
2. Use a wrench to tighten the nut, and the water pipes of the hot water pipe will be connected on both sides.
3. The inner wire is directly connected to the upper and lower inlets of the solar water heater, tee diameter connection, solenoid valve connection and the outer wire is directly connected to the cold water valve. as well as the outer wire and wateru tap. The connection of the interface, as well as the connection of the three-way hot water pipe and the water mixer, which is used to discharge hot water.
The rising and falling solar water pipes are hot water pipes, so you cannot connect the cold water pipes, unless your solar is installed in a place where it is convenient for you to get on and off. So you can add a valve near the water inlet of the solar water tank. Then connect the water pipes anywhere on the upper and lower water pipes (hot water is needed when the water is hot, cold water is needed when cold water is needed). water is needed, close the valve near the outlet and open the water supply valve.
Villa Master offers you local house construction policies, house construction drawings and house design drawings.e villa;
Villa appearance rendering services, thousands of popular designs for you to choose from: https://www.bieshu.com?bdfc