Are you asking how to fill antifreeze in Four Seasons Muge solar water heater? The steps to fill the antifreeze in the Four Seasons Muge solar water heater are as follows:
1. # sleeve to open the filling cap (be careful not to lose the seal).
2. Use a low-pressure DC injection pump to start injecting liquid until liquid flows out of the water tank fill port, which is considered full.
3. Tighten the cap containing the gasket with a sleeve and cover it with the decorative cover.
Media Addition Location for Smith Solar Water Heater
Operating media include: water and antifreeze. Thermal-conductive silica gelor thermally conductive ceramic sheets are often media, and they must be taken apart to see the details.
Open the filling cover ofliquid in the middle and upper part of the balcony wall-mounted solar water heater tank, unscrew the sealing screw cap, as well as the liquid filling port (upper position) and observe. port (lower position) will appear.
Find a pipe. The outer diameter of the pipe should be smaller than the diameter of the liquid filling port. Insert one end of the hose into the liquid fill port. Lift the other end higher than the liquid inlet and start filling the antifreeze inside with a pointed jar or other container. Stop filling when antifreeze flows from the inspection port.
Notes on filling antifreeze:
1. Do not fill when the sun is strong, to avoid being unable to fill due to thermal shrinkage of antifreeze. The best time to refuel is in the morning before sunrise and in the afternoon after sunset.L.
2. During the antifreeze filling process, if the antifreeze overflows from the observation port, stop filling and refill after a few minutes. The aim is to evacuate the gas present in the water tank, the collector and the connecting pipes.
3. When adding antifreeze, a larger basin should be connected to the ground to prevent the antifreeze from flowing to the ground.
The cleaning method is as follows:
1. Remove the vacuum tube and handle it gently without breaking it. 2. Pour the balance. 3. Clean the scale inside; wall of the solar vacuum tube. A special acid descaler is required.
Pour in acidic scale remover and soak for about ten minutes, then use the brush to pull back and forth to remove the remaining scale, then rinse twice with clean water.
1. Open the liquid adding cover in the middle and top of the balcony wall-mounted solar water heater tank.
2. Unscrew the sealing screw cap and the liquid filling port (upper position) and observation port (lower position) will appear. Smith Company is a multinational enterprise with a splendid history Relying on advanced technology, high quality products and perfect services, it has become the largest water heater manufacturer in North America and is a listed company in the New York stock exchange.