The maintenance method of solar water supply is as follows:
1. Water pressure problem if the water pressure is too low, water supply will not be possible. Wait until the water pressure is high. before supplying water or purchasing a booster pump. This guarantees the water supply. In winter, check to see if the pipe temperature is too low and causing ice blockage, and wait until there is sufficient sunlight before filling the pipe with water.
2. Check if water pipes, valves and water supply valves are blocked. Turn off the water switch. Use a screwdriver to open the solenoid valve at the water inlet end. Be careful. There is a very fine needle inside. Then carefully align the needle and install it. to be determined.
3. The water level sensor is damaged, causing the water pump to idle for a period of time.long time and burns. Please ask the repair staff to help you repair it.
Solar energy is a renewable energy source. It refers to the energy of thermal radiation from the sun and its main manifestation is often called solar rays. Nowadays, it is typically used to generate electricity or provide energy for water heaters.
Since the birth of life on earth, it has mainly relied on the energy of thermal radiation provided by the sun. Since ancient times, humans have also known how to use sunlight to dry objects and use it as a method. to prepare food, such as making salt and drying salted fish. With the decline of fossil fuels, solar energy has become a significant part of human energy consumption and continues to grow. There are two ways to use solar energy: phototh conversionthermal and photoelectric conversion. Solar power generation is an emerging renewable energy source. Solar energy in a broad sense also includes wind energy, chemical energy, hydropower, etc. on earth.
1. You need to confirm whether automatic water filling is set. If it is automatic water filling, it will definitely display the water filling status.
2. Solar energy continues to fill the water. This may be due to failure of the temperature and water level sensors or failure of the solenoid valve. It cannot be turned off when the water is full. .
3. The indoor water mixer is defective. Cold water and hot water are the same and are in a slow supply state.
4. Automatic water filling is not set, but manual water filling is set. However, if the water is not filled, it still indicates that the wateris full. the water level sensor probe, and simply replace it.