Insert the solar tube.
There is a circle of grooves on the solar silicone pad. When you place it, first attach a small edge of the silicone pad with the inner tank of the water tank, then tighten it clockwise. step by step. Note: When installing, you need to insert the rubber pad into the solar tube, with the large end facing outward and the small end facing inward into the solar water tank.
Solar energy is a renewable energy source. It refers to the radiant thermal energy of the sun (see the three modes of propagation of thermal energy: radiation), and its main manifestation is often called solar rays. Nowadays, it is typically used to generate electricity or provide energy for water heaters.
If there is a water leak at the connection of thesolar water heater water pipe, follow the following steps to check:
1. The connection between the water pipe. and the seal. It depends on the type of pipe you use. Hot melt In the case of pipes, the connection is not good enough when hot melting, causing water leakage; in the case of aluminum-plastic pipes, screws are not; tight or the sealing ring is damaged.
2. The connection between the joint and the water tank pipe is often caused by the raw material tape not being properly wrapped, causing water leakage.
3. The connection between the water tank pipe and the water tank. There are two commonly used connection methods: solder type and silicone gasket type. ?If it is a welded type, the water tank needs to be replaced. If the warranty period has expired, you need to find an argon arc welder to remove the layer of isolation and weld it. ? If it is a silicone type of seal, simply replace the sealing ring. If there is no replacement in stock, you can replace the exhaust port sealing ring on the top and use it (general solar is universal).
4. Close the water tap.
5. Then use a wrench to loosen the leaking gasket and remove it. First check if the joint pipe connection is cracked.
6. If necessary, replace it. If not, check if the pipe head is flat. After smoothing, reconnect the joint. Pay attention to the second proof. The aluminum plastic pipe must be inserted. In the seal. Inside, if you don't understand, you can ask a plumber for help. Once the pipes are laid, tighten the joints and there should be no leaks.
7. If there is water leaking between the pipe fittings, simply remove it and wrap theTape the threaded end for about 20 turns. Then reconnect it and tighten it.
8. There is also white pipe, but this type of pipe is PVC water supply pipe. If it leaks, simply wrap the raw material tape around the joint.
9. If there is water leakage at the place connected by glue, it is best to cut the leaking place with pipe scissors and replace it with a new one.