This is a very common installation method in which hot and cold water share the same pipe. That is, the solar water supply and the hot water outlet are both installed through the same water pipe.
When the tap water pressure is sufficient, after turning on the water supply switch, the hot water in the water tank will not be used. At this time, all hot water taps will come out with cold water. When the tap water pressure is not enough, the hot water from the water tank will not be used. Turn on the water supply switch and the hot water from the solar water tank will flow back into the tap water pipe.
Installation method:
1. Run a water hose from the cold water tank to one end of the mixer;
2. solar water tank (upper and lower outlets), "One or two of the tops of the solar water tank areexhaust ports or overflow ports. They are filled with water to give signals and cannot be blocked.") Run a water line to the At the other end of the mixer, [pass the mixer (required. There is a switch with a pump (If the mixer does not have a water supply switch, a three-way connection. channels should be connected at both ends and a ball valve switch should be connected in the middle to supply water to solar power
<); has two You can connect a pipe with a water pump to directly fill the cold water tank Otherwise, add a tee to the water pump on the connecting pipe between the mixer and the cold water tank (add a. check valve or ball switch between the water pump and the tee to eprevent water from flowing back into the water pump).How to use:
1. If you want to collect water from the cold water tank, simply pump it directly with the water pump. When the water is full, turn it off. ball switch. It is easier to use the check valve and turn off the water pump directly.
2. If you pump water into the solar water tank, use the water supply switch of the mixer. Valve for supplying water with solar energy. When the water is full, turn off the switch.