Are you asking about the glass tube on the solar panel? There is a small tail at one end of the glass tube and a mouth at the other end. When installing, apply dish soap on it, insert it into the glass tube. water storage bucket and place the mat on the small At the back end, pull the tube down a little so the tube and mat are closer together
Hope this helps
How to repair a leaking solar tube
< p>Solar water heater disassembly method:
Materials to prepare : solar water heater, maintenance equipment
Materials to prepare: solar water heater, maintenance equipment
1. When disassembling, you must follow the steps. The first thing that needs to be clarified is the power off operation. Before dismantling and draining the water, you must first think about turning off the power, and that. must be carried out before the rrepairs. Otherwise, electric shock may occur during the disassembly process.
2. The first thing you should pay attention to when disassembling is that you must first remove the water from the insulated water tank to avoid burns from high temperature hot water during disassembly, and even if the the water in the water tank has been drained, it must also be left for a period of time until the temperature has completely dissipated before disassembly and maintenance can be carried out.
3. During the disassembly process, if it is not cleaned for a long time, it may be difficult to disassemble and it may even be damaged. Therefore, necessary protective measures must be taken during dismantling. Rubber gloves should be worn to avoid damage during disassembly. Scratches caused by improper operation.
4. Generally speaking, the vacuum tube of aSolar water heater is the most difficult part to remove, so the vacuum tube needs to be disassembled mainly. In addition, due to water rust, etc., the vacuum tube. must be carefully turned. It should be noted that there are seals at the upper and lower ends of the vacuum tube to prevent damage and loss.
5. After removing the vacuum tube and placing it in a safe place, you can disassemble the insulated water tank. However, it should be noted that after unscrewing the screws, two people need to work together to do so. lift the water tank. This process is not difficult, you just need to be careful. When disassembling, the parts of the insulated water tank should be stored to avoid damage or loss.
The repair methods for solar tube leakage are as follows:
1. The first situation is that the solar water tank. is enddamaged and causes water leakage, if the water tank leaks, it should be repaired in time, otherwise it should be replaced with a new one.
2. The second situation is that the solar water pipe is leaking. This situation is caused by the water pipe aging for a long time. Just replace it with a new one.
3. The third situation is that the sealing ring at the connection ages and causes water leaks. This can be fixed by replacing the sealing ring at the connection.
4. The fourth situation is that the solar solenoid valve fails. Removing it for repair or replacing it with a new one may solve the problem.
5. The fifth situation is that the solar collector is broken, causing water to leak into the overflow pipe, exhaust pipe and cap. This can be fixed by replacing the sensor.
Causes of solar tube leaks
1. If the suction hose is broken, water will flow out;
2. The pipe connection is loose or the pipe fittings are aged or damaged, such as the faucet is not tight, metal valves or pipes and other parts. The damage will cause water leakage;
3. The seal is damaged or loose, causing solar water leakage;
4. defective, resulting in no water supply, resulting in water leakage.