Yes.
1. Be sure to comply with applicable laws and regulations and consult before disassembly or contact relevant departments for disassembly procedures.
2. Pay attention to safety during the disassembly process to avoid accidents caused by improper operation.
3. If you install new equipment after dismantling it, you should ask professionals to install it to ensure the quality of the installation.
How to remove the heating pipe from the solar water heater?
If you can dismantle solar power that hasn't been used for a long time, you should dismantle it!
If it is really difficult to disassemble or transport, it is best to keep enough water inside.
As long as there is enough water in solar energy it will not work. be damaged when the sun shines. If it is lowered, it will not cause energysolar, solar tube bursting, etc.
Of course, you can also do it over it appropriately and cover it with a certain sunshade device
< p>How to disassemble the heating pipe of the solar water heater:
1. First of all, it is better to choose a cloudy day, morning or evening, because you need to remove the heat from the solar water heater first before dismantling it. Drain all the water to avoid burning yourself from the hot water that seeps in when removing the hose. If it is noon at this time, since the water in the vacuum tube has emitted light, the strong sunlight will damage the vacuum tube and shorten its service life.
2. When disassembling, it is best to use water soaked in detergent or washing powder to lubricate the vacuum tube. At the same time, pay attention to the angle of the vacuum tube and avoid it. pull the angle to prevent the vacuum tube from bursting. After disassembly, the vacuum tube must be epacked in special polyester foam compartments and placed in special cartons to avoid shocks during transport.
3. Use water soaked in detergent or washing powder to lubricate the connection between the vacuum tube and the water tank, then turn it left and right and press it in lightly, then remove the other end of the Remove the vacuum tube of the circlip. Carefully remove the vacuum tube from the tank.
Detailed information:
Solar water heater leak repair
1. Water tank leak
Solar insulation Water leaks are relatively rare. If upon inspection it is found that the water tank liner is indeed leaking, then you should consider replacing the solar water tank. The quality and age of the water tank coating directly causes the water tank to rust and leak. But in general, the solar seal ring is generallynot damaged. In this case, just ask the master to come and replace a few silicone solar rings.
2. Water pipe leak
If the water pipe is leaking or the water pipe is leaking, it is because the PPR water pipe or aluminum-plastic pipe has aged after years of wind. and exposure to the sun. This situation It is necessary to replace the solar hot water pipe. A valve leak means a valve failure. In this case, a new solar valve or solenoid valve must be replaced.
3. The solar heating pipe is leaking
If the solar heating pipe is leaking from the electric heater position, it means that the electric heater is rusty and damaged, and a new seal or the electric heating rod must be replaced. Solar vacuum tube leakageWater is basically the aging of the solar silicone ring, and the vacuum tube needs to be repulled and replaced with a new silicone ring. Water leaks from the solar exhaust outlet are usually caused by damaged sensors or meters. In this case, the water temperature and level meter or a new solar meter must be replaced.
Reference documents:
Baidu Encyclopedia - Solar water heater