For complete disassembly, you must first empty the water from the water tank, remove the upper and lower water pipes and external connections, then remove the pipes and finally remove the bracket. During the process of removing the pipe, first move the pipe a little deeper into the water tank, turn it slowly, remove the lower part of the pipe from the pipe holder, and then remove it. If you encounter a tube that is difficult to remove, first lower the beam that holds the tube support underneath. Use cardboard to pad the bottom of the tube, then remove it one by one. The price is subject to actual conditions.
How to disassemble a solar water heater
First disconnect the power supply, close the water supply tap, go to the roof, open the sewage drain to let the water run, or disconnect a few pipes, prepare 2 before removing the pipes A bottle of mineral water, filledfill it with water, add a small amount of detergent to lubricate it, drill a few holes in the cover, spray water on the tube to lubricate it, so that the glass tube can be easily removed, and pull out the ring sealing down for some movement. Okay, twist the hose a few times and insert it a little into the water tank, so that there is space underneath to easily remove the hose holder. . Place the pipes in place. Arrange the 6 pipes in a triangle and use a wide transparent tape. Bundle the two ends together for easy transport. Use pipe scissors to directly cut pipes, wires and signal wires (be sure to disconnect the power). food). Cut off any water pipes and wires entering the room beforehand, and simply remove the pipes (if you keep it on, water will flow down the pipe when it rains), then remove it. water tanku from the shelf, and simply carry the rest downstairs. The shelf can be removed or not, it depends on the specific situation.
Removal method of Xinxiang solar water heater
The operation method must first cut off the power supply to avoid electric shock, and then proceed with subsequent operations safely and orderly. Then drain the water from the insulated water tank and wait for the temperature of the water tank to return to low before proceeding to the next stage of the dismantling and repair work. Then you can proceed to dismantling work. When disassembling, you should pay attention to appropriate protective measures to avoid damage to parts and scratches due to improper operation or operation.
The disassembly process of Xinxiang solar water heater should be carried out carefully. Here are the specific steps.
Step 1: First remove allhe water pipes and power cords to the water heater. Be sure to turn off the power supply to avoid any risk of electric shock.
Step 2: Remove the solar collector bracket. The support is very important because it supports the entire solar collector system. The bracket and solar collector are usually attached with screws, so you need to use a wrench or electric wrench to remove it.
Step 3: Disassemble the solar collector. Solar collectors are usually mounted on brackets, so before disassembly, you need to use an electric wrench or wrench to remove the screws and remove the solar collector one by one.
Step 4: Remove the water tank. The water tank of the solar water heater is usually installed on the roof and should be removed using an electric wrench or wrench and placed in a suitable place.
Step 5: Disassemble the pipeline. Carefully remove the connections between the tpipes and solar water heater. If necessary, use a wrench or pliers to facilitate removal.
Step 6: Arrange the disassembled parts. The disassembled parts of the solar water heater should be sorted and sorted into categories.
In short, disassembly of the Xinxiang solar water heater requires patience and caution, so as not to damage the parts for further use or recycling. The dismantled solar water heater can be sent to the relevant recycling sites or recycled by other channels.