The reasons why the solar water heater does not produce water are:
1. The water in the water tank was drained until it was filled with water and heated in the sun before. to use.
2. If the hose interface is loose or blocked, reconnect it or clear the hose.
3. In winter, water pipes can freeze. It will melt on its own about 3 hours after sunrise. In cold areas, a drain valve can also be installed.
4. The upper and lower water valves are leaking, the water supply valve is also leaking, and the water pipe has been dry for a long time, causing water to flow back. This situation requires repair and solution.
5. The nozzle valve or hot water nozzle is malfunctioning and is not actually open, so it needs to be repaired.
There are many reasons why hot water comes from solar energy but cannotbe released. The following situations may occur:
1. When water flows through the solar water heater, scale appears. will be produced. Yes, if it is not cleaned for a long time, the water inlet and outlet pipes will be blocked, preventing water from flowing out. Water pipes must be cleaned and maintained.
2. The vacuum tube of the solar power may be broken. If the vacuum tube is broken, solar energy cannot be collected and water cannot be heated. must be replaced.
3. The solar pipes are leaking, preventing solar energy from being used normally, and the pipes need to be repaired.
4. There is too much dust on the solar heat absorbing tube, which affects the thermal absorption effect of the heat absorbing tube, preventing the solar energy from heating.
5. The solar water storage system may be broken and there is not enough ewarm stored during the day.
6. If water is supplied automatically, the probe may be faulty and water cannot be supplied. Naturally there will be no hot water.
7. If a fully automatic auxiliary water tank is installed, the auxiliary water tank float valve may not be closed properly or may fail, resulting in continuous replenishment of cold water and a drop in water temperature. . The float valve and associated parts need to be replaced.
8. If the tap water pressure is too high, even if there is hot water in the solar energy, it will not be released. You can slightly close the water inlet valve behind the water meter. to adjust the water pressure.