How to clean solar vacuum tubes:
1. Use a cloth to clean dust, dirt, etc. on the surface of the vacuum tube to avoid slipping when disassembling the vacuum tube.
2. Use a screwdriver to pry up the dust ring on the upper end of the vacuum tube and slide it down about a foot.
3. Wearing non-slip, heat-resistant gloves, grasp the outermost vacuum tube firmly and slowly rotate it upwards. During rotation, the vacuum tube will enter the water tank about ten centimeters.
4. Once the vacuum tube has penetrated about ten centimeters, you can see that the bottom of the vacuum tube has come out of the rear bracket. At this time, you should grasp the vacuum tube with both hands and. remove it slowly. Follow the same steps to remove the other vacuum tubes.
5. Once the vacuum tube has been dismantled, allthe water inside the vacuum tube must be drained. If there is a lot of scale inside, you can inject an appropriate amount of clean water and shake the vacuum cleaner. tube continuously, then pour the waste water again. After the poured water becomes clear and there is no more scale in the vacuum tube, you can stop rinsing and pour water.
6. Reinstall the vacuum tube in the reverse order of previous disassembly and install the dust ring in its original position. Once the installation is completed, you can use solar energy normally.
How to clean dirt in solar tubes
Solar cleaning methods are as follows:
Tools: screwdriver, gloves, refined detergent.
1. Remove the sealing ring and slowly pry it out with a screwdriver.
2. It takes a lot of effort to dismantle the solar tubes, which corrode over time. Be prough and remove them slowly if possible to avoid scratches.
3. Remove the sewage and dirt in the pipe, use a blunt tool to clean the scale, pay attention to protecting the inner tank, and use plenty of clean water to clean the scale.
4. Dip some detergent thinner on top of the solar tube and carefully reinstall the solar tube.
Principles of solar energy technology
Solar energy is generated by the fusion of hydrogen and helium atoms at the interior of the sun to release enormous nuclear energy. is the radiant energy of the sun. Most of the energy needed by humans comes directly or indirectly from the sun. Plants release oxygen, absorb carbon dioxide through photosynthesis, convert solar energy into chemical energy and store it in the plant body.
Fossil fuels such asCoal, oil and natural gas are also primary energy sources formed by the evolution of ancient animals and plants buried underground over a long geological period. Energy is usually contained in the earth itself. refers to energy related to thermal energy within the earth and energy associated with nuclear reactions.
1. Rinse with water or remove with a brush. If the scale is very hard, you can use an electric or hydraulic pipe cleaner to clean it. This method is more suitable for the early stages of tartar formation.
2. Use electrical signals to change the molecular structure of water to accelerate the release of minerals and allow the minerals to be closely combined, and the combined minerals are carried away by the water flow, which can prevent the formation of tartar.
3. These methods can effectively preventscale formation, such as using magnesium rods, adding minerals, magnetizing, etc.
Detailed information:
Notes:
1. the solar water heater is installed correctly, follow the instructions to understand how to use the solar water heater and the functions of the water heater components to facilitate further management and maintenance.
2. Familiarize yourself with the structure of the solar support. The outdoor unit of the solar water heater is mainly composed of an insulated water tank, a hot-dip galvanized bracket, a solar vacuum tube and a breathing valve. Among them, the water tank Insulated water and the vacuum tube of the water heater are the most important and are determined separately to improve the heat retention and heat collection performance of solar water heaters.
3. The heat preservation efficiency of water tank de heat preservation determines the heat preservation efficiency. The quality of the foam layer of the heat preservation box determines the capacity of the heat preservation water tank. of Sun Rain water retention water tank reaches 96%. The patented thermal insulation wall and thermal insulation film technologies make the thermal insulation more stable, and the red breathing valve above the water tank can also ensure the internal pressure balance of the water.
Baidu Encyclopedia-Solar Energy