Cold water from solar energy can be released, but hot water cannot be released due to the following reasons:
1. The vacuum tube is damaged and needs to be replaced;
2. Sewer Pipes and Valves Or the joint is leaking and the sewer pipe needs to be repaired
3. The tap water pressure is high and the hot water cannot flow out, so the tap; water flow should be reduced;
4. This proves that there is a problem with the sensor, solar energy cannot fill the water, please replace the sensor of the same model
5. . The probe is condensed, you can remove the probe and sand it and you will be fine.
6. The instrument display is faulty (if the water level, time and water supply functions on the instrument are normal, this is not a problem) or the temperature probe is faulty .
7. First test the approximate outlet water temperature. If the temperature is very high,this means that the sensor is defective. If it is still at normal temperature, it is an electric heating fault or a heating problem. failure of the leak protector.
The reasons are:
The pipes and joints of solar sewers are leaking, preventing the hot water from draining. Or the tap water pressure is too high, preventing hot water from coming out and the tap water needs to be turned down. Or the solar water heater may have a water leak, preventing hot water from flowing out.