According to the query on Aiguou.com, the solution to the leaking solar seal ring is as follows:
1. Check the position of the seal ring; the seal ring not only needs to be replaced, but also needs to be inspected. Is the installation location correct? Correct installation method can prevent deformation of the seal ring and achieve better sealing effect.
2. Check the installation: Checking the installation is an important part of solving the water leak problem. Make sure all accessories are well connected and there is no play. At the same time, check whether the water pipes are leaking or deformed. If there are any problems, they must be resolved in time.
3. Find the cause of the fault: If none of the above methods can solve the problem, you need to further check the general condition of the solar water heater, find the causeof the leak and prescribe the right medication to resolve the problem.
The operation steps are as follows:
Push the solar tube up to separate the bottom part from the base, then pull it down and remove -THE. make the bottom part look like a thermos bottle. The small silicone solar glass column inside was damaged, otherwise it would not be insulated. Remove the silicone ring and replace it, press it in the opposite direction and you will be fine. When installing, apply a little soapy water to the glass column, which is more convenient.
Detailed information:
Daily maintenance of solar water heater
< p >1. When installing a solar water heater, there may be a smell of dust or oil in the water pipe. When using it for the first time, you can first open the faucet to remove debris.2. The water stored in the solar water heater should be discharged regularly depending on local water quality conditions. Drain time can be selected in the morning when the sensor temperature is lower.
3. The surface of the solar water heater should be wiped regularly depending on the amount of dust in the area. It can be cleaned when it rains. Keeping the water heater surface clean can get higher heat. collection efficiency.
4. When hot water is not used for several consecutive sunny days, the hot water temperature will be very high. When using the solar water heater, please turn on the cold water first, then turn on the cold water. hot water to avoid burns.
5. There is usually a filter device at the outlet end of the faucet. Scale and debris in the water line accumulate on this screen. It must be removed and cleaned regularlyierly to increase the water flow. smooth the flow.
6. In winter, it is very common for pipes to freeze. If it turns out that the pipe has frozen but is not yet cracked, it can usually be cleaned automatically after the temperature rises. You can also use a hair dryer to blow on the water line, or wrap a towel around the water line and then slowly pour warm water over it. Do not cook it on fire, hit the water pipe, or scald it with boiling water, because. this will cause the pipe to burst. Multiple freeze blockages can easily cause pipes to freeze and crack. Pipe insulation measures must therefore be reinforced.
7. Solar water heaters should be cleaned, inspected and disinfected on average every two to three years. Users can also carry out some disinfection work themselves. Egexample, they can buy disinfectants containing chlorine. and add them to the water. Pour it into your mouth, soak it for a while, and then release it, which can achieve a certain disinfectant effect.
8. Solar water heater On average, the inside of the vacuum tube needs to be cleaned every two to three years to prevent scale from forming inside the vacuum tube and affecting the heat absorption effect .
9. If the solar water heater is equipped with special instruments, please pay attention to lightning and electricity protection. Do not take a shower and unplug the electric heater during lightning.
Baidu Encyclopedia: Solar Water Heater