Leaks in solar water pipes require first determining the specific location and cause of the water leak in solar water pipes, and then taking measurements appropriate repairs depending on the actual situation.
If the connection position of the water supply pipe is loose, the loose position should be tightened. If the water pipe is slightly broken, you should first wrap wire around the broken position and make sure it is wrapped tightly, then use adhesive to wet the wire. When the adhesive is dry, the broken position will be normal there. There will be no water leaks.
If the water pipe breakage is very serious, it cannot be repaired, and the water pipe can only be replaced with a new product of the same specifications and models.
Solar lifespan:
Generally, the lifespan of water heater products isQualified olears is 15 years, but this is based on the media not rusting or warping. The water tank coating thickness is SUS304-2B, greater than 0.3.
The solar lifespan mainly depends on the vacuum tube. The middle part of the vacuum tube solar water heater plays a vital role. The lifespan of solar water heater mainly depends on the quality of solar vacuum tube.
1. Water Tank Leak: There are generally two situations when water tanks leak. If the water tank liner leaks, it is recommended to replace the solar water heater tank. If the solar seal ring is damaged, in this case, you just need to replace the solar silicone ring.
2. Water pipe leak: If the water pipe is leaking or the water pipe is leaking, it is because the PPR water pipe or aluminum-plastic pipe has aged after years ofwind and sun. the exhibition. Replace with solar hot water. Take care of it. A valve leak means a valve failure. In this case, a new solar valve or solenoid valve must be replaced.
3. Solar heating pipe leaks: Solar heating pipe leaks in electric heating position. Generally, the electric heater is rusty and damaged, and a new sealing ring or electric heater rod needs to be replaced. Water leakage of the solar vacuum tube is basically caused by the aging of the solar silicone ring, and the vacuum tube needs to be removed and replaced with a new silicone ring. Water leaks from the solar exhaust outlet are usually caused by damaged sensors or meters. In this case, the water temperature and level meter or a new solar meter must be replaced.
4. Leaking water pipe : If the connection between the water pipe and the joint is leaking, in the case of hot melt pipes, the connection is not good enough when hot melting. aluminum-plastic pipes, the screws are not tightened or the sealing ring is damaged. If the connection between the joint and the water tank pipe is leaking, it is probably because the raw material tape is not wound properly. If the connection between the water tank pipe and the water tank is leaking, and it is welded type, it is recommended to replace the water tank or find an argon arc welder to remove the insulation layer and weld it if it is one; type of silicone seal, simply replace the sealing ring.