Changchun solar water heater is a kind of water heater. The withdrawal method is as follows:
1. Turn off the power switch of the solar water heater and unplug the power plug to ensure that the power supply will not continue to supply electricity.
2. Turn off the electrical power at the water pipe interface of the water heater to ensure that there is no pressure or hot water inside the water heater.
3. Remove the infrared solenoid valve from the water heater and turn off the power to the water pipe interface on the infrared solenoid valve.
4. Remove the water heater housing. It should be noted that insulating materials such as cottons and sealants should also be removed, and sediment inside the water heater should be removed to ensure proper operation. clean and tidy.
5. Remove the solar vacuum tubes from the water heatersolar one by one, use a special tool to tighten the suction cup, then pull gently. When removing, you must pay attention to protect the suction cup to avoid damage.
6. Finally, place all components in a clean, dry place for safekeeping or disposal.
In short, you should be very careful when disassembling the Changchun solar water heater to avoid damaging the device or causing injury to yourself.
How to disassemble and assemble a solar water heater
Unreasonable, it is illegal. Whoever gives you the right can touch your belongings at will, just like your television, the solar water heater belongs to your private property, no one has the right to take it away from you without your authorization. If someone takes you down, call the police. If the police don't care about you, file a lawsuit with the police too and sue them for doing nothing.
Disassembly and assemblysolar water heaters require certain skills and precautions. Here are the general steps for disassembly and assembly of solar water heaters:
Disassembly of solar water heaters:
Turn off the water heater: First of all, make sure that the hot water supply to the solar water heater is turned off. You can close the valve connected to the water heater or turn off the power to the water heater.
Drain the water heater: Open the water heater drain valve and completely drain the water from the water heater. This step aims to reduce weight during disassembly and prevent water leaks.
Disconnect the water pipe: Use a wrench or other suitable tool to gently loosen the connection between the solar water heater and the water pipe. This usually includes the inlet and outlet pipes.
Disconnect the power source (if applicable): If the solar water heater is running on an electrical source, make sure the power supplyentation is cut and the electrical connection is disconnected.
Remove the mounting bolts: Check the mounting bolts or brackets of the solar water heater, use suitable tools to loosen and remove them.
Lift the water heater carefully: Lift the solar water heater carefully to ensure that it is not damaged or bumped during transportation.
Installing a solar water heater:
Prepare the installation location: Choose a suitable location to install the solar water heater and ensure that the support or the fixture is firm and reliable.
Install the fixing bolts: According to the design and requirements of the solar water heater, install the fixing bolts or brackets in the predetermined position.
Connect the water pipe: Connect the water inlet pipe and the water outlet pipe, make sure the connections are tight and bwell sealed. Use appropriate sealing materials, such as pipe sealing tape or pipe putty, if necessary.
Connect to a power source (if applicable): If your solar water heater requires a power source, make sure it is properly connected and perform all safety checks. necessary security.
Water Filling: Open the water inlet valve and inject water into the solar water heater system. Make sure the water is circulating properly and check for leaks.