Simply install an anti-limescale device for drinking water specially designed to eliminate scale on the cold water inlet pipe of the solar water heater. First, it prevents the generation of new scale during the heating process. Second, the original tartar will gradually disappear. soften and fall off on its own. The third is to improve thermal efficiency, prevent the heating rod from bursting, and extend the life of the solar water heater;
How to clean scale in solar water heaters, how to remove water and alkalis with solar energy
Buy an anti-scale device specially designed to remove scale scale and install it on the solar water inlet pipe.
First, it can prevent new tartar from forming. Second, the original scale will gradually soften, fall off and be discharged. Third, it can improve the quality of eau, increase the thermal efficiency of solar energy and extend. lifetime.
How to clean the scale inside the solar water heater:
Hold a vacuum tube with both hands and rotate it back and forth. back to loosen it from the sealing ring to the water tank, then place it in the water tank. Push it for a while. When the bottom can be separated from the base, remove the vacuum tube, pour out the water, then add clean water, rinse it and pour out. Repeat this several times until it is thoroughly rinsed. Then disassemble and clean the next one. After all cleaning, add water to the water tank, rinse the scale and debris into the water tank, then install the vacuum tubes one by one. 1. Before safety, carefully check whether the sealing ring at the water tank installation hole is intact. If damaged and aged, the seal ringity must be replaced by a new one. The scale in the vacuum tube floats in the water and will not stick to the inner wall of the water tank like the scale in the thermos bottle, so it is relatively simple to clean, but you need to be careful when disassembling and do not do it. use too much force to avoid damaging the vacuum tube.