First of all, make sure that there is no problem with the water supply. Clean the filter, check the water supply valve, then disconnect the solar water supply pipe from the solar power, add water and check that no water comes out, it means the pipeline is not is not good. outside, clean the solar inlet and outlet and check the overflow port and exhaust port for blockages. If there are no problems and no water is coming out, you can simply disconnect a vacuum tube, add water and rinse it further, and there should be no problems. Cleaning a solar water heater is actually very simple and you don't need to find anyone else. Just add an acidic solution to the solar (usually adding a little acetic acid for home use is enough, but it's okay if you don't add vinegar), soak it for a moment, thenrinse it with clean water. . Each vacuum tube should be cleaned to improve thermal efficiency. When removing the vacuum tube, first slowly push the vacuum tube into the water tank, then remove the tailstock, and then remove the vacuum tube. When installing, first insert the tube a little more into the water tank, install the stock, then remove it to hold it against the stock. Hope this works and helps you.
Your solar panel has been filled with water in the last two days and has run out of water even though it has not been used at all. This means there is a problem with your solar water switch. supply valve, or there is something wrong with the water outlet valve, in short, after going to Sheung Shui Pavilion, you must ensure that the water supply is turned off at night or at some point in your home. Because the valve is not closed tightly and the wateris stopped, the water automatically slides down the pipe, so when you use water, you feel the water at work, and it is gone before you know it. supply water, so that the water in the supply pipe can be There is a certain distance between the water and the water. Avoid siphoning into water pipes