1. Prepare the required materials and tools, including sealing rings, and clean the installation area.
2. Place the new sealing ring with the front side facing out and place it into the solar glass tube. Fix a point first, then use a straight line to gradually install the remaining part into the glass tube. .
3. Touch the edge of the seal ring with your hand to ensure that it is installed smoothly and will not slip.
How to install a solar seal ring?
1. First use tools to remove the damaged sealant and make sure the surrounding area is clean
2. Place the prepared sealant side out;
3. Confirm a fixed point and use a screwdriver to install the sealant on the stainless steel inner body;
4. If it is clean and smooth and does not move, that means the installation is over; .
What are the functions of solar water heater sealing rings?
1. Prevent foreign objects from entering the water tank
There are two types of sealing rings for solar water heaters. One of them is installed on the suction pipe of the solar water heater. the solar water heater. In this case it is used. The sealing ring must be able to prevent dust or other foreign matter from entering the water heater tank, otherwise the dust or other foreign matter may corrode the internal sealing ring, causing the internal seal. Ring to accelerate aging, resulting in water leakage and other situations.
2. Prevent water seepage and heat preservation
There is also a sealing ring installed inside the water tank. According to professionals, the sealing ring in this case is instgone on the glass tube. , It mainly has the function of sealing, preventing leakage of the inner tank of the water tank and maintaining heat. If installed incorrectly, the inner tank may leak or fail to be insulated.
3. Aesthetic effect
The sealing ring installed on the vacuum pipe of the solar water heater can also have a certain decorative effect.
What should we pay attention to when using solar energy?
1. If it is the first time to use water, it is necessary to wait for the temperature inside the vacuum tube to drop to prevent the vacuum tube from breaking, affecting normal use, or even causing danger.
2. If you don't need to use solar energy, you need to tighten the hot water faucet and water supply valve. If you take a bath, you must turn off the water supply tap and turn on the tapwater supply. When filling water, the upper and lower valves must be opened.
3. When the water is filled, the water inside the overflow pipe will flow out and the hot water tap should be opened for a few minutes to allow the water in the water tank to drain. flow slightly. avoid heat loss.
Are the solar water heater sealing rings and dust rings the same?
Replace 16 to 16mm. The method is as follows:
1. Remove the water inlet hose by turning it counterclockwise, remove the original water inlet hose, remove and install the new water inlet hose.
2. When replacing the sealing ring, you should choose a sealing ring that matches the diameter of the vacuum tube. There are three common sizes available: 16mm, 32mm and 64mm.
3. Once the fillingacement finished, you need to use a wrench to tighten it clockwise.
The sealing ring of the solar water heater is different from the dust ring. The main function of the sealing ring inside is to prevent solar water from leaking, while the dust-proof ring outside is to prevent solar water leakage. prevent dust from entering the solar power. If the vacuum tube sealing ring is damaged or aged, it should be replaced with a new one.
Steps to replace the sealing ring:
The sealing ring is installed in the middle of the water tank. You can first rotate the vacuum tube left and right, loosen it and then push it. When the bottom can be removed from the base, pull it down again, remove the vacuum tube, remove the sealing ring and replace it, then reinstall the vacuum tube.