Non-flammable.
The solar water heater is a heating device that converts solar energy into thermal energy, heating water from low temperature to high temperature to meet the use of the hot water by people in life and production. Solar water heaters are divided into vacuum tube solar water heaters and flat panel solar water heaters based on their structural shapes. Evacuated tube solar water heaters are mainly used, accounting for 95% of the domestic market share.
Home evacuated tube solar water heaters are composed of heat collecting tubes, water storage tanks, brackets and other related parts. The conversion of solar energy into thermal energy mainly relies on vacuum tubes which use the principle that hot water is used. floats and cold water sinks, causing microcirculation of water pto obtain the required hot water.
Can Siji Muge thermal solar oil be refilled?
The replacement steps are as follows:
1 . Open the lid. on the solar water heater.
2. Open the pressure relief valve to release pressure in the water heater liner.
3. Remove the thermal oil inlet and outlet pipes and clean the remaining thermal oil.
4. Inject new thermal oil into the inner tank of the solar water heater and install the inlet and outlet pipes.
5. After installing the inlet and outlet pipes, open the pressure relief valve and check for oil leakage.
6. Close the solar water heater cover, perform a heating test and check whether the thermal oil is working properly.
Can continue the family. According to the instructions for use of Siji Muge Solar, we learned that the solar oilthermal Siji Muge must be added depending on the life of the fluid. Under normal circumstances, solar thermal oil should be added once every 2 to 3 years. can use two thermal oils apart from solar. The fill holes are one top and one bottom. Fill the top hole until the thermal oil flows out from the bottom hole, which means the thermal oil is full, so Siji Muge solar thermal oil can be used. added again.