Five ways to clean green moss in water pipes:
1. First, scald the inside of the pipe with boiling water. Boiling water should be boiled, then immediately poured inside the pipe. It can burn the foam and can also be rinsed away.
2. Rinse the pipes with salt water. Salt water can effectively clean waste and scum in pipes. Mix the salt with boiling water and wait until the salt water is completely mixed before using.
3. Use an algaecide to kill moss on the pipes. Algaecide can be purchased online and in supermarkets. Just follow the instructions for use.
4. Use special cleaning agent to clean the pipes to achieve the effect of cleaning the pipes. Cleaning products can be purchased online or at water pipe stores.
5. Lime can be usedto remove foam from pipes. Simply sprinkle a little lime directly into the pipe, then rinse it with tap water.
Why is the water in solar water heater slippery? How to clean scale from a solar water heater?
Many people in rural areas install solar water heaters. Solar water heaters that were once popular in rural areas are now rarely installed because, in many cases, if it rains and there is no sun, the solar water heater is useless and it is easy to damage it. if there is hail. In addition, the solar water heater is not easy to clean after prolonged use, and it is easy to produce a lot of foam and a rancid smell.
In many cases, solar water heaters provide hot water as long as there is sunshine. However, in many places there is sometimes no sun when it rainst and the water heater is not working. to use. Installing solar water heaters is quite tedious. It is also expensive and can only rely on the sun to produce heat and boil water. It often happens that there is no hot water available. For example, there is very little sunlight in winter, so there is no point in installing solar energy. In winter, people want to take a hot bath, but there is no sunshine or hot water available, so few people install it. Additionally, installing solar is more complicated than water heaters, as you have to connect water from the roof and install pipes, etc. In rural areas, tap water has just been installed, so the water pressure is not enough. And if your floor is relatively high, the water pressure will not increase at all. Filling solar water heaters with water is also a problem. Meme for a two story bungalow it is difficult to live on the water. In addition, the way of installing the installed pipes is also a problem, which is why few people install them in rural areas. Solar water heaters are more difficult to install and transport, and their glass tubes break easily. Additionally, the hoses will easily produce foam after long use. Solar power will easily get a rancid smell if not cleaned for a long time. Generally speaking, solar water heaters always depend on the sun and nature, so in many cases, when there is no sun, the solar installation is useless. That's why few people install it.
How to deal with moss growing on water pipes at home?
Why is the water in the solar water heater slippery strong>
Waterof the solar water heater is a little slippery because it has deteriorated after repeated heating. When the water of the solar water heater is heated in the water tank for a long time, foam and other substances will be produced, so the water will be a little slippery. Because the solar energy in the solar tube leaks, the water in the sun is burned by the sun, and when it contacts the air, it will produce a mossy water bath, almost impossible to see, so the The water is smooth and there is foam in the tube, just like a river. There is also light on the stones inside.
Usually, we fill the water heater naturally after taking a shower at night. If the temperature is low in winter, it is easy to freeze the water outlet pipe of the water heater, so everyone can go and fill it. water the next morning. If the temperature is not very low, you can fill it with moity of water. If you take a shower in the evening and you still have hot water left, you can fill it with water.
How to clean scale in solar water heaters
When cleaning, choose a time when the weather is good, not in summer or sunny weather , otherwise the temperature will be too high. Not conducive to cleaning and easy to burn. Before washing, drain the hot water inside, then pour in cold water, then drain to avoid scalding. Then prepare the plastic chain panel, remove the sealing ring of the heating tube, hold the heating tube with both hands and lift it up. Once the bottom is separated from the holder, the heating tube can be removed.
For disassembly, the heating tube can be cleaned starting from the side. You can pour water into it to rinse it. If the scale is stubborn, you can pour a little cleaning product and stir it with a PVC pipe. After cleaningthe stick, store it to prevent it from breaking. Then clean the water tank, spray a special cleaning agent into the water tank, rinse it with clean water, then drain the scale, and finally clean the appearance of the water heater again.
Can the water from the solar water heater be drunk?
The water from the solar water heater cannot be drunk. Although solar energy water is tap water, after years of accumulation in hot water pipes, a lot of dirt will appear in the pipes, and solar energy water contains more impurities and rust, and contains a lot of harmful substances, which It will cause harm if you drink it to human health.
1. Use toilet cleaning fluid; 2. Use lime water; 3. Use table salt; No matter which one you use, you need to be careful. safety during its use. All the foregoing. A peu corrosive. Once cleaning is complete, remember to fill it with tap water and rinse it thoroughly to prevent corrosion of the water pipes.
Only plastic pipes that can transmit light are likely to form foam. Replace light-permeable water pipes.
Cover water pipes exposed to the sun with something. Don't let the sun shine. This will reduce the foam a lot! I learned this while repairing solar panels.
The moss in the glue tube is caused by the water inside being exposed to direct sunlight for a long time. Once grown, provided you bury the glue tube less than 10 cm into the ground or wrap it with grass, parasol or anti-freeze sponge, it will disappear slowly. If you want to clean it immediately, there is no quick way short of changing the hose. Remember to protect it in accordance with the requirements aboveess after replacing it.
1. Find the cause of the humidity and prevent it from developing further.
2. It can only be repaired after drying. ?Cook the water pipes with fire. ?Replace the water pipe? The "Pipe Tong" that I bought from Kaolin works well. Everything in the pipe is removed and the pipe is not damaged. Is it also very convenient to use? Add copper sulfate (a substance that kills moss). at the water inlet. ), leave it closed for two days without draining the water, and the foam will be gone. Replace the water pipe? Regularly put chlorine dioxide (the best product for sterilizing tap water) in the well to sterilize it and avoid chlorine. water well away from the sun.
3. Install a water inlet filter at a height lower than the water depth. ?Is it for the washing machine or for the shower? Replace it with a new one? ?Did you install the pipes yourself? Ofmoss will grow on pipes when exposed to sunlight. If you want to clean them thoroughly, bury them deeper.