In this case, the chances of replacing it without breaking the wall are very low. The solenoid valve is connected to the water pipe below the mixer and to the water pipe above the mixer. Caliper< /strong>WrenchJust unscrew it. When folding it, please note that you must drain all the water from the water tank first, then close the main water inlet valve before use.
The upper exhaust is leaking. When the solar power is filled with water, the normal situation is that the water will overflow and leak first if the water supply valve is not closed in time. due to the rapid flow of water, overflow will occur slowly, excess water will be discharged from the upper exhaust, which is normal.
If the upper exhaust pipe is emptied first, you can pull the overflow pipe down 1-2 cm, or lift the upper exhaust pipe up by approximately 1 cm. THEBucket lid leaks. The bucket lid usually does not leak. If it leaks, the silicone ring of the vacuum tube may be broken. Water flows into the bucket lid along the foam material and flows out of the bucket lid. .
When moving to a new house, there are three water valves, a main water valve and a solar water distribution valve. What is the third one for?
< p>It should be in the solar water tank in summer. The water temperature is too high and the tap water pressure is unstable.
When you encounter this situation, first try to avoid swimming during peak water consumption times.
The second is to purchase online the installation and use of a thermostatic water valve dedicated to solar water heaters.
I think the general residential water supply and drainage system should be a three or four systemother pipes, because some places in the residential building need hot water, such as bathrooms and kitchens. At the same time, some places need cold water, such as bathroom, toilet. Cold water and hot water can share a drainage pipe, but they will not share a water supply pipe, because on the one hand it is a waste of energy, and on the other hand the measurement heat is annoying. Therefore, there are three water valves. , one is the main water valve and the other is the solar water distribution valve (that is, the hot water inlet valve), and the third should be the valve cold water inlet!