How to remove the solar electric heating rod

1. Use pliers to remove all power cords outside.

2. Then remove the connection wires around the water heater one by one.

3. Use a screwdriver to remove all the small screws around it.

4. Use a wrench to unscrew the surrounding large screws.

5. Then you can remove the outer fixed cover.

6. Finally, you can remove the heating rod from the water heater.

Detailed information:

< p>Heating pipes are used in a wide range of applications, such as air conditioners, water heaters, humidifiers, etc., all equipped with heating pipes. Principle of heating tube: It uses the resistance wire inside the electric heating tube to heat. The heating tube converts the electrical energy consumed into thermal energy to heat the materials to be heated.

During operation, the low temperature fluid enters its inlet port through the pressure pipeline and along the specific heat exchange flow channel inside the electric heating tank, using the path designed according to the principle of fluid thermodynamics. , it removes the electric heating element during operation. The generated high-temperature thermal energy increases the temperature of the heated medium, and the high-temperature medium required by the process is obtained at the outlet of the electric heating tube.

Note: Choose a heating tube that suits you according to your own needs. Because heating tubes are also divided into power sizes.

1. First of all, it is better to choose a cloudy day, morning or evening when dismantling, because you need to drain all the hot water from the water heater before dismantling (to avoid being damaged when dismantling).pipe assembly) Burns due to seepage of hot water). If it is noon at this time, because the water in the vacuum tube has emitted light, the strong sunlight will damage the vacuum tube and shorten its service life.

2. When disassembling, it is best to use water soaked in detergent or washing powder to lubricate the vacuum tube. At the same time, pay attention to the angle of the vacuum tube and avoid it. pull the angle to prevent the vacuum tube from bursting. After disassembly, the vacuum tube must be packed in special polyester foam compartments and placed in special cartons to avoid shock during transportation. (The most important thing is to disassemble the vacuum tube, because this step is the most difficult and dangerous for non-professionals.)

3. Disassembly method: Use water and dish soap or laundry detergent. to lubricate the vacuum tube At the connection point with the water tank, turnsz it left and right and push it slightly, then take out the other end of the vacuum tube from the circlip, and gently pull the vacuum tube out of the water tank.