If you guessed correctly, you are talking about a leak at the sensor inlet of the solar water heater, right? Typically, the sensor is inserted through the top overflow port on one side of the water tank. used when the water is full. It is designed to overflow excess water. If there is a leak in this port, the first signal is to remind you that the water is full. If you are using an automatic water supply device and the overflow port has a continuous water flow, the problem lies in the automatic water supply, that is, your water supply Automatic water will only supply water and will not stop. situation. Have or take a look.
Huangming Solar hs 14tt18 sensor port leaks:
1. The vacuum tube leaks when you use it in spring and summer, remember that when there is no water in the bucket, you can do it. choose only at night or early in the morning. When water is fsupplied to a newly installed solar system, the temperature inside the tube rises rapidly at noon. Sudden application of cold water will rupture the vacuum tube.
If the vacuum tube is cracked and leaking, the solution is to close the water supply valve and turn off the power supply for automatic water supply. Once the water in the bucket has drained, remove the broken tube. It is recommended to use lubricant. Apply it to the vacuum tube, first hold the vacuum tube, insert the vacuum tube into the water tank until the other end of the vacuum tube leaves the bracket, then tilt the tube broken. The vacuum tube is broken and needs to be replaced with a new one.
To replace the installation method, first place a dust ring (black leather ring) on the non-tip of the vacuum tube, apply detergent (diluted is fine ) on the non-tip, then insert it into the bucket. Remove it again andPress the tip of the vacuum tube against the plastic backing of the stand.
2. The upper exhaust is leaking. When the solar power is filled with water, the normal situation is that the water overflows and leaks first. If the water supply valve is not closed in time, the water. will flow quickly and the overflow will be slow. Excess water will be discharged from the upper exhaust, which is normal.
If the upper exhaust pipe is emptied first, you can remove the overflow pipe 1-2 cm downwards (the overflow pipe does not require welding) or lift the upper exhaust pipe approximately 1 cm upwards.
3. The bucket lid is leaking. The bucket lid usually does not leak, the vacuum tube silicone ring may be broken. material and flows out of the bucket lid. If the silicone ring is not broken, it can be replaced within the warranty period.