The solution for slow and low solar hot water production is as follows:
Tools: Siji Muge solar water heater, small booster pump domestic, thick water pipe.
1. Appropriately increase the height of the solar power to increase the height difference, or use larger diameter upper and lower water pipes or add a small household booster pump.
2. The pipeline is long and has bends, which hinders the flow of hot water. Rearrange the pipeline and there are blockages at the inlet and outlet or the upper and lower water pipes.
Solar Cleaning Tips
When cleaning solar power, remove the vacuum tube and pour out the scale. You can then use diluted hydrochloric acid to clean it. It is best to wear gloves (it is best to use the water the day before, fromdisassemble and wash it early the next morning and finish it before sunrise). It's usually best to have a professional wash it.
The cleaning interval of the glass tube should be determined according to the local conditions of the water source (high hardness of the water source is easy to eliminate if there is no does not have much scale, it is not necessary to clean). frequently, because when the glass tube is disassembled, it is easy to do so. If the seal ring is damaged, check it carefully before installation. If it is damaged, replace it with a new one to ensure that there will be no water leakage after installation. .
The solar water is evacuated by the height difference and the pressure is too low. If hot water production is low, it is a height difference problem. the solar water heater
1. Replace the pipe and increase the diameterbe of the pipe.
2. Add a miniature booster pump to the water outlet of the solar water heater.
3. There is now a supercharged shower that does not have electrical supercharging. As long as the cold water flows normally, it can flush the hot water after use, there will be at least 3 times. more hot water than before use. It can also prevent hot and cold, anti-scalding, anti-scaling, thermostatic valve is omitted.
4. It would be better to add a booster pump and use a small booster nozzle.