There are two possibilities for this situation. The water mixer may be broken or the hot water outlet pipe may be broken.
1. The return pipe of the solar water heater is an overflow pipe. Once the water is filled, the overflowing water flows through this pipe.
2. On a sunny day, the solar energy continues to heat and the water temperature continues to rise. When water expands with heat and shrinks above 4 degrees, the water level in the solar water tank. will rise slowly and is higher than the overflow, so the water will flow out, giving people the feeling of constant running water. In fact, this is a normal phenomenon.
3. Maybe your water supply valve is broken and not closed tightly, that is, it is still in a small water supply state, or there are hot and cold water flowing to other areas of yourhome, and solar energy continues to replenish the cold water.
4. The temporary solution is to close the solar main valve and water supply valve once the water is full, take the time to open the main valve and check the cause as soon as possible.
Related Instructions
Solar water heaters should be cleaned, inspected and disinfected every two to three years on average. Users can also perform some disinfection by. For example, you can buy a disinfectant containing chlorine and pour it into the water inlet, soak it for a while, and then release it, which can achieve a certain disinfection and sterilization effect.
It is very common for pipes to freeze in the winter. If the pipe is found to have frozen but not yet cracked, it can usually be cleared automatically after the temperature rises. You canAlso use a hair dryer to blow on the water line, or wrap a towel around the water line and then slowly pour it with warm water. Do not cook it on fire, hit the water pipe, or scald it with boiling water, because. this will cause the pipe to burst. Multiple freeze blockages can easily cause pipes to freeze and crack. Pipe insulation measures must therefore be reinforced.
The solar nozzle is still blocked and the water flow is too low. Does anyone know how to fix the problem
The nozzle is stainless steel?
Solar water heaters generally have low hot water outlet pressure, so don't choose those that are nice and beautiful
Those nozzles that have water flow important and look tall and elegant. not suitable for solar energy.
Try to choose a non-pressure nozzle or a nozzleunder pressure.
It has nothing to do with the material, haha, it has to do with the structure
The main reason is that there are minerals in the water after long use. Over time, scale builds up into the solids around the nozzle outlet hole, causing a blockage. Just clean the nozzle outlet hole. If it's a nipple, you can rub it with your hands. Otherwise, you can prick it with a sharp object such as a steel needle. You must be careful not to hurt your hands. outlet too large, which will waste water.