Your solar automatic water filling device can be a fully automatic electronic water filling device. After a certain period of use of an electronic product, some parts may malfunction. Professional inspection and maintenance is recommended. Illegal use may cause unnecessary physical injury and property damage. Xiangyang Solar Energy (Air Energy) Hot Water Engineering Center will answer your questions and hope to help you.
Energy
1. Pay attention to antifreeze during daily use
Solar water heaters can generally be used normally in sunny weather. days in winter When the temperature is low When the temperature is 0°C, it is best to use water from the water heater in small quantities and several times a day, especially before going to bed in the evening andafter getting up the next day. day, you can put a small amount of water to make the water flow into the pipe and rely on the water temperature to increase the pipe temperature. The lower the temperature, the more water must be drained to prevent water pipes from freezing and. blocking.
2. Fill the water according to different weather conditions
When the temperature is not too low (5-7℃), after using water that night, if there is more hot water. in the water tank, it is advisable to immediately fill the solar water heater with water to reduce the water temperature in the water tank and heat loss that night; if the temperature is low, it is advisable to refill the water the next morning to; helps prevent pipes leaving the water heater from freezing; if it rains or snows the next day, you can add half a tank of water or more than half a tankwater according to actual needs.
3. Antifreeze and pipe insulation are essential.
Particular attention should be paid to antifreeze in solar water heater pipes, especially at the connection between the water tank and the water supply. It is easy to shake when the water flows. If the connection is not good, the water supply pipe will be easily exposed in cold weather, it will easily freeze and block, preventing hot water from entering and the water supply pipe. Cold water cannot come out. Therefore, the water supply pipe must be well insulated. Generally, the length of an insulating pipe is two meters, and the joints of each insulating pipe should be tightly tied with tape to prevent them from getting stuck. disconnected in case of strong wind or flooding.
4. Use the heating anti-freeze device correctly
Generally, solar energy isequipped with an anti-freeze heating device. Many consumers often use it to defrost the pipe after it has frozen. In fact, it not only delays the use and damages the lifespan of solar energy. The correct way to use it is that when the recent temperature continues to be below 0℃, the antifreeze device should be turned on to carry out preheating protection. If the nighttime temperature is relatively low in winter, the antifreeze device can be activated at night and turned off during the day. When taking a bath, be sure to unplug and turn off the power supply to avoid accidents caused by loss of thermal balance.
5. Turn on the water flowing from the hot water tap to prevent freezing.
In winter, you should pay more attention to the weather forecast when the temperature drops below -7℃. , you need to empty the water tank after running out of hot waterthe night. Fill it with water, then connect a basin under the nozzle or faucet. Loosen the hot water faucet a little and let it drip slowly to maintain water flow. In the pipe. Generally, the flow of one basin of water per night can avoid blocking the flow of water in the pipe, it is also an effective way to prevent solar pipes from freezing.