It is better to choose a cloudy day when you want to disassemble the solar tube. First, drain all the water from the solar panel. Start by removing the first tube from the solar side and attach the rubber ring at the connection. between the vacuum tube and the water tank. Hold both ends of the vacuum tube with both hands, twist it left and right to remove the vacuum tube from the base, and then remove it while rotating it.
From a safety point of view, it is better to hire professionals to disassemble solar tubes, because some solar tubes that have been used for a long time are difficult to disassemble safely. When dismantling the solar tubes, you cannot choose a weather with strong sunshine, because when dismantling the solar tubes, you need to drain all the water from the solar panels. If the sun is too strong and there is no water in the tubes, the strong light from the ssun will do it. shorten the life of vacuum tubes, or even damage the vacuum tube.
When disassembling the solar tube, it is best to use water soaked in detergent or lye to lubricate the vacuum tube. Remove the rubber ring between the vacuum tube and the water tank, then hold the vacuum tube with it. with both hands and use a little force to remove the other end of the vacuum tube. Remove one end of the circlip, then gently remove the vacuum tube from the water tank. During the disassembly process, you should not use too much force, otherwise the solar tube may burst and cause injury to people. Therefore, non-professionals should pay attention to safety when disassembling the solar tube.
During the process of disassembling the solar tube, if the rubber ring cannot rotate for a long time, you can use dishwashing liquid to apply to the contact area betweenthe tube and the silicone ring to increase lubrication, then apply it to the rubber ring. When disassembling the solar tube, it is best to disassemble it from the first tube on the solar side, which will make the operation easier.
The solar vacuum tube burst due to freezing. Can I buy a vacuum tube and install it myself? What is the specific installation method?
The installation steps are as follows:
1. Insert the solar vacuum tube into the vacuum tube hole of the water tank. You can insert more sections. .
2. After installation, apply force evenly and keep the direction of the force consistent with the coaxial line of the pipe mouth with the other hand.
3. Moisten the windshield ring with clean water, place it on the upper end of the vacuum tube and expose the port. Hold the tail of the tube with one hand to protect it. The end of the queeu. A vacuum tube can be installed.
4. Follow the steps above to install all the vacuum tubes in order.
Of course you can
Nowadays, there are usually four to seven tubes and five to eight tubes. The lengths are also not necessarily the same.
It is recommended to measure the size yourself or bring the broken pipe when purchasing.
There is nothing special about the installation, you just need to push the hose into the water tank. first, then remove the bottom pipe holder (or twist the tube out of the tube holder)
Then remove it. Do not throw away the top silicone ring, store it.
When installing, be careful not to place the silicone ring crooked. If the new pipe is difficult to block, you can soak it in a little soap. water.
The method is the reverse process of disassembly, which is very simple.