You can use a wrench to tighten the leaking gasket so that the leak no longer occurs. If the solar heating pipe joint continues to leak after retightening, it is necessary to dismantle the joint and check whether the internal pipes are cracked. If broken, cracked accessories must be replaced. After replacement, reinstall the solar. Heating pipe. Just put the pipe joint on. 1. First, use a screwdriver to loosen the joint nut of the solar heating pipe and check whether the head inside the pipe is flat. If the aluminum-plastic pipe is not inserted into the joint, you must unscrew the aluminum-plastic pipe. again and insert it into the joint. Usage Tighten the nut of the aluminum-plastic pipe with a screwdriver and turn the switch back on. If there is still water leaking, you must remove the pipe fitting for inspection. 2. Then wrap the other side with the thread withtape for a few turns. It will take approximately 20 turns to fully tighten the thread. Then simply tighten the pipe connections. However, there is another type of material for the pipe. This pipe is white and made of PVC. For pipes of this quality, you must use glue to solidify it. 3. Finally, reinstall all the removed nuts and accessories into the pipe, matching them one by one, and then reopen the common switch of the solar heating pipe. If there is no more water leaking, this proves that the repair is complete. However, in the event of a water leak, the entire heating pipe must be replaced.
It can be installed completely! You need to pay attention to some details here. First check whether the rubber ring at the solar water tank interface is damaged, you can replace it directly. with a new rubber ring. I have a few more here. Maybe you cane use them if there is no obvious damage, you can install the solar water tank/bracket first, but do not tighten the four screws at the connection. Between the solar water tank and the bracket, but you need to align the screw rods on the solar water tank. Place the holes on the quasi-support. At this point, use common household dishwashing liquid to spread a circle around the mouth of the holder. vacuum tube to lubricate it. In this way, slowly screw it in like a light bulb. Insert the solar vacuum tube into the water tank. Finally, it will be installed on the tailstock because it is inserted too deep. time, you just need to pull the vacuum tube towards the tailstock in the opposite direction. If there is a black dust ring on the vacuum tube, it is still recommended to install it. Otherwise, it doesn't matter. I have a lot of these dust rings here. If you need it, you can apPlease contact us directly to request them and you will be responsible for postage costs. Of course, if you are a friend of Fuzhou. I will come and help you. Also don't damage the vacuum tubes. I have vacuum tubes here, but the cost of taking them is very high. Otherwise, I will contact my local friends to help you. you.