Of course, it is about the use of solar energy.
Solar water heaters, solar panels, etc. all use solar energy to convert solar energy into thermal energy or electrical energy.
The solar water heater is currently the most energy efficient type of water heater. If possible, it is best to install a solar water heater.
What is the working principle of solar water heater?
① Solar power, wind power, water power, etc. can be continuously obtained from nature and can be reused, and are limited renewable energy sources; reserves on earth and will not be replaced after consumption. It can be regenerated, but it is a non-renewable energy source;
②There are many ways to use solar energy. the internal energy of water.
So the answer is: internal renewable;
Principle diagramoperation of solar water heater 1. Cold water enters the solar water heater through the pipe, passes through the heat collecting plate and the heat collecting plate can collect solar energy, convert solar energy in thermal energy. energy, then heat the cold water. Since the density of cold water is higher than that of hot water, the hot water will automatically increase and then form circulating power. The water will gradually heat up on the heat collecting plate. After reaching a certain temperature, it can enter. the hot water tank. Those who need hot water will be able to get hot water at any time. Heating Figure 2. In fact, the principle of solar water heaters mainly includes the following two principles: (1) The principle of water circulation, that is, the water flows automatically. This is based on the fact that cold water is denser thanhot water. Cold water flows and hot water rises, forming natural convection that gradually heats the water in the water tank until it reaches the set water temperature. When the intensity of the sun is not sufficient to meet circulation needs, a water pump can be added to the closed water circulation circuit to obtain forced circulation. (2) Collector heat absorption principle: There is a special coating on the collector surface of the solar water heater. This coating has a high absorption rate in the visible range of solar energy. After absorbing it in the form of heat, heat. the radiation from the collector will have the wavelength in the longwave range and the coating has low longwave emissivity, thus effectively retaining solar heat. This heat is then used to gradually heat the cold water into hot water. Collector tube solaire Let's talk in detail about the header tube on this header. The collection tube is actually like an elongated hot water bottle liner. It is made of two glass tubes, one large and one small. the inner layer is covered with a spectrally selective absorption coating and a straight void is drawn between the inner and outer tubes. It forms the core of the solar water heater and is used to maximize the absorption of thermal energy after solar radiation due to vacuum. The glass tube is round, has the characteristics of naturally following the wide source of the sun, coupled with the reflection principle of the reflector, the glass tube can receive light from all sides, the heat collection effect lasts longer , the water temperature is higher, and it can work normally all year round, even in alpine areas.