The wall-mounted solar water heater for balconies, if its collector is removed, can be considered as an electric water heater with pressurized water storage. Generally, this type of pressurized water storage water heater, in order. to prevent it from In terms of internal heat exchange area, the heat exchange area of the jacket and coil is larger than that of the small inner tank. In terms of average flow, the forced circulation system is better than the natural system. traffic. In terms of heat exchange materials, enamel is mainly used for inner-jacketed water tanks, copper coils are better than enamel coils.
How to use: When the tap water stops, close valve No. 1 and open valve No. 2 to be able to adjust the water temperature. How to fill the water tank: open valve No. 1, then open valve No. 2. When the water tankwater is full, close valve No. 2. When installing, connect a rubber hose under the pressure relief valve. can connect a basin or bucket underneath. If the water heater is leaking when it is turned off, it means the pressure relief valve is broken. You can call the after-sales service for repair. After the warranty period, go to the hardware store and purchase a replacement.
Find the specific leak point and the specific cause of the leak. If the pipe is broken, we need to buy a water pipe of the same specification and then replace it if it is caused by looseness at the pipe. Interface Water leak. In this case, the reasons for the leakage of the solar water heater are as follows: firstly, the connection between the upper and lower water pipes and the water tank interface is not tight and the pipe connections are damaged, causing water leakage. the nozzle loosens, prsuggesting a water heater leak; second, the electric water storage type. The water heater's inner tank is corroded by scale, causing water to leak.
In terms of heat exchange surface, the heat exchange surface of the jacket and the coil is larger than that of the small liner. In terms of average flow, the forced circulation system is better than the natural system. traffic. In terms of heat exchange material, most tweezers with enamel coating are used. In water tank, copper coil is better than enamel coil. The outlet of the working fluid from the collector flows along the pipe into the water storage tank. transfer heat to the water in the water storage tank, causing the water temperature to increase. At the same time, the low temperature working fluid flows from the working fluid inlet of the collector, and afterbeen heated, flows and then flows into the water storage tank.
The first method is to use a three-way hose connection on the hot water end of the mixer tap. One end of the tee is connected to the mixer, one end is connected to the mixer. Solar energy, and the other end is connected to the water heater. Install additional water valves and check valves at both solar and water heater openings.
Secondly, install a water valve at the water outlet of the water heater, and add a water valve and check valve conveniently in the main water pipe room solar hot water (the check valve must be installed horizontally).
The third option is to find a sink with four holes, or add four holes. Install two hot and cold faucets. Personally, I recommend using it.
Note: It is not recommended to user hot water from solar energy in the sink.