The information is taken from the Internet, for reference only
The reason for the shutdown is that the oil separation is not coordinated well enough. Pay attention to the following two points and practice more.
1. Quickly lift the clutch with your left foot to the semi-binding point. The car is about to move forward, lightly press the accelerator with your right foot and the speed will reach. around 1200-1500. At the same time, continue to slowly release the clutch with your left foot. The right foot continues to apply the gas simultaneously. Once the clutch is fully released, the car continues to move forward. 1500-1800, it shifts to 2nd gear, then changes gear every 2000.
2. Park in front of the traffic light and away from the white line, but not too far away, half a parking space is enough.
When the red light passes just 4 seconds, you can lift the clutchage. When semi-linked, you can step on the accelerator and release the clutch at the same time. turns green, you will rush, then quickly shift from first gear to second gear, then shift to third gear, press the accelerator a little longer in third gear to get more power and accelerate faster, and finally will pass quickly. in fourth and fifth gears. This way it is faster than other cars and does not stall due to impatience.
How to start the manual transmission without stopping it
1. When you get in the car, you should adjust your seat so that your thighs and lower legs can flex and stretch freely. This is very important. You cannot drive the car well if you are not seated properly;
2. When you press the clutch, you must press the clutch all the way down withyour left foot, otherwise there will be a problem. There will be a click when shifting into gear, otherwise the gear will not change. It is easy to damage the gearbox;
3. Shift into gear, shift into 1st gear. Many novices shift gears very hard. which is not recommended. You need to be gentle and shift to the corresponding speed based on the upper trajectory. Impossible to start in 2nd gear. The gear distribution of each car is different, please follow the gear lever instructions to engage;
4. Release the handbrake, also known as the parking brake, and the likelihood of stalling. is particularly high. You must remember:
5. Release the clutch. The clutch connection point of each car is different. Therefore, when you drive a car for the first time, you must slowly lift the clutch to find. the point of semi-bond. Remember whether the binding point is higher or shorter, the binding point occurs when the car shakes slightly when the clutch is released. After mastering the car's binding point, you should quickly raise your left foot to the binding point when starting;
6. Many novices do not accelerate when starting. They simply release the clutch. and wait for the car to move before pressing the accelerator. This is also a significant reason for slow startup and stalling. The clutch must be released and the accelerator must be released at the same time. Novices start with a heavy throttle as the clutch is released. is not released to the binding point or is too slow. As soon as the car moves, the clutch should be released at a constant speed.