1. First, open the oil fill port of the DJI T40 generator and add oil up to the marked line. When filling engine oil, pay attention to the type and quality of engine oil and follow applicable specifications and standards.
2. Then close the oil filling port of the DJI T40 and start the generator, then let it run for a while to allow the oil to fully circulate and lubricate.
3. Finally, close the oil filler port and start the generator, let it run for a while and check again if the oil level is on the marked line. You can complete the DJI T40 generator oil reset.
Which generator is used to charge the DJI T40
The oil cylinder is poorly lubricated. Generator wheezing refers to the phenomenon that the diesel generator set has a long life.iodine and is relatively smooth and fast and slow in the low and medium speed range. Questioning its equipment shows that the wheezing of the DJI T40 power generation equipment is caused by poor oil lubrication. Adjustments can be made by wiping with lubricant.
DJI T40 generator model: BAX601-30000mAh-52.22V.
The temperature of the charging environment is between 5℃ and 40℃.
The built-in battery life is 3.3 hours.
The external battery life is 2.7 hours.
The charging method uses a USB-C fast charging charger with a maximum power of 65W (maximum voltage 20V). It is recommended to use a DJI portable charger.
Charging time for built-in, built-in and external batteries is 2 hours (off state follows the official charging method).