It has a lot to do with the angle. If the angle is large, the 261 AP will not necessarily penetrate it, but the 30mm hull is the thinnest and can penetrate a small area above the turret mantle with a penetration depth of over 180mm . Can also be worn. -7 The defense is pretty good. There is a slight angle on the front of the body, so it is invincible. However, the penetration depth of the front and bottom is relatively speaking, it can penetrate up to 240mm. The hole that has a high probability of penetration is the front of the turret. The rat's front shell is not invincible, but if it does not require any angle, there is always a chance of penetration. The front of the turret is very fragile except for the gun mask, and the angle impact is relatively small.
Please check whether the circuit contact is good, whether the air switch screws are loose, etc.
You dPlease reconnect the line or tighten any loose screws.
The specific operations are as follows: Prepare the tools you need, such as multimeters, screwdrivers, insulating gloves, etc., as well as new plugs or accessories. What is the specific problem of using an electric pen to test the voltage detection number? Unscrew the socket housing and test all four screw positions. If one side has power and the other side has no power, this is normal. If the live wire has no power but the neutral wire has power, it's a switch problem. air switch. If there is still no power, continue to the next step. Check whether the socket wiring box and board hole are complete. If there is power, it may drop or be disconnected due to prolonged use. Use an electric pen to test the circuit. If two of the three wires are live, this signify. that the circuit in the wall is defective. You need to find a professional to repair it in time. After replacing the new outlet, the L mark is the live wire, the N mark is the neutral wire, and the E is the ground wire. Do not connect the three wires backwards. Usually it will work normally after replacing it with a new one. . If there is still no power after replacing the new power strip, it can also be determined that there is a problem with the neutral circuit in the wall. Turn off the power and wait for a professional electrician to come to your home for an inspection.