If the engine oil burns, the car may not be able to start and the cylinder may also be torn off. Engine oil is called the blood of the engine. It lubricates, cleans and seals the engine. The role of heat dissipation.
If there is no oil in the engine, the engine will not run properly. When using the car, you should always pay attention to whether the amount of oil in the engine is sufficient when the engine is running. , the oil will be in various parts of the engine. An oil film forms on the surface, which reduces friction and heat generation.
If there is a lack of oil in the engine, the rapid friction between different parts of the engine will instantly generate a large amount of heat, resulting in cylinder pulling or bearing erosion . . When you use your car, you should perform regular maintenance and oil changes.
Detailed information:
The quality of the engine is the key to determining the quality of the motorcycle When choosing, first observe whether the engine and the frame are on the same center line, and then pedal in neutral Start lever, if no sound is heard, the engine cylinder is OK.
Connect the power supply, turn on the fuel tank switch, and start in place to check the engine starting and shifting conditions. A good engine can and will start by pressing the start gear lever 2-3 times. does not stall at idle. There is no noise and the acceleration is very responsive.
Perform a gear shift check and shift from low gear to high gear step by step. The gear change is smooth. There is no collision sound in each gear when shiftingspeed change. There is no air leak. in the muffler nut even if the quality is good. Finally, observe the color of the smoke emitted from the muffler, light cyan is best.
If a car burning oil won't start, is it stuck on the cylinder?
Once the oil burns out, the automatic flameout will fire the cylinder? When oil burns, it means that when the engine burns oil and all the oil is used up, it means that the oil in the engine is out of service. This phenomenon is serious: burning engine oil will consume a lot of engine oil. At the same time, it will cause insufficient ignition of gases in the engine combustion chamber, increase carbon deposits and reduce engine power.
If the engine oil burns, it will lead to insufficient lubrication of the engine parts, increase the pressure on the friction surface of the parts, worsenthe degree of damage and gaps between parts will also persist. to expand. At the same time, the engine cannot be cooled and dissipated in time, which can cause burns, cylinder pulling, etc. In the long term, the aging of engine parts will be accelerated and the life of the engine will be shortened.
You can add oil at the same time after it has toasted, but it depends on the situation. If there is a lack of oil, when the engine is already badly damaged, adding oil will not save. To replace damaged components, it is best to visit a repair shop for a more detailed inspection.
If there is a shortage of refrigerant, otherwise it will not result in a good cooling effect. At this time, the engine should be dissipated in time and the refrigerant should be replenished, otherwise the engine may easily pull the cylinder when driving.te, and in serious cases, the engine. The piston may be damaged. The axles and pistons of the engine, which will also be more troublesome when the time comes to resolve them.
Millions in car purchase subsidies
What's the problem if the generator doesn't work?
It There are many reasons why a car that burns oil cannot start. The spark plug may be filled with carbon deposits, the fuel injector may be clogged or there may be too much water in the fuel, the starter motor may be damaged, etc. The precise reason can only be determined by going to the repair shop for inspection. .
Most cars burn oil because the piston rings are covered in carbon deposits. Relying on adding high viscosity engine oil to extend service life is only a temporary measure that only solves the problem, but notthe root cause. When oil enters the combustion chamber and participates in combustion, more carbon deposits will be formed, which in turn will lead to increased oil combustion, thus forming a vicious cycle. If this continues, the cylinder wall will be strained, or even the cylinder will explode, and eventually the engine will have to be dismantled for an overhaul.
At present, it is difficult to fundamentally eliminate the problem of fuel oil combustion, but you can regularly clean the oil lines, carbon deposits and sludge when daily maintenance to prevent the occurrence of fuel oil combustion.
Four reasons to burn engine oil
If you do not clean the oil circuit for a long time or do not clean effectively the oil circuit, use detergents as desired. Use detergent and Use effective cleanersare two different things;
The antifreeze replacement cycle is too long or not replaced at all;
The oil replacement cycle is too long;
p>
4. Long term or frequent travel over short distances.
A vehicle that burns engine oil at the four points above must occupy one or all four points.
How are piston rings stuck?
The principle of piston ring sticking starts from the oil circuit. The engine oil withstand temperature is 110 degrees. oil The high temperature caused by long-term uncleanliness of the road causes the engine oil to stay at a temperature of 120 degrees or more for a long time, so that the engine oil is exhausted prematurely. very small, and the engine oil inside will be dried, crusted and stuck over a long period of time. A stuck cylinder means a liter of engine oil every 5,000 kmbeings. At this time, the other cylinder blocks will soon begin to malfunction. all four cylinders are blocked, and this will become one liter of engine oil every 1,000 kilometers or even hundreds of kilometers. Therefore, to solve the problem, one must start from the root of the oil circuit, which is the only way to eliminate the root.
Methods to solve the problem of burning oil
In the inertial thinking of car enthusiasts, they always think that burning oil should be resolved by revision. will not only bear the high cost. In addition to maintenance costs, you also have to bear the unpredictable risks and depreciation losses caused by vehicle overhaul. Destroy the tightness and precision of the motor. In addition, it is possible to burn oil again after tens of thousands of kilometers, so engine overhaul is not sustainable.
The current non-dismantling technology is very mature and gradually accepted by the majority of car owners. In particular, the fourth generation of Siyoupu non-destructive repair products has completely moved away from the technical constraints of auto repair shop operation, can be operated by the car owner himself without removing a single screw. The effect of repairing and releasing stuck piston rings burning oil while driving is remarkable.
The generator cannot turn on or start:
1. First check if the engine oil and gasoline (diesel) have been added recently. Otherwise, the old one if that's the case. been added for more than three months, the engine oil and gasoline (diesel) must be drained and replaced again. (Since engine oil and gasoline (diesel) are only valid for three months, oil and gasoline (diesel) that havebeen used for more than three months have lost their viscosity and have no effect.
2. engine oil and gasoline used in generators? Stock up. If it is not filled, the generator will not ignite or start.
3. ignition. Since the generator is not used often, it will not start. It is difficult to start when used, because the oil level in the carburetor drops due to infrequent use, causing corrosion in the carburetor, which blocks operation. oil hole. Oil returns to the oil pan after a long period of non-starting. There is no oil in the oil pan when starting. The engine oil is lubricated and the cylinder pressure cannot be achieved. too much gasoline (cold oil) is not burned and the spark plug is clogged (the spark plug is wet). Remove the spark plug, wipe it clean, burn it with a lighter and simply put it back or replace itby one. a new candle