5KW Low Speed Electric Vehicle Range Extender
The range extender can be started by hand, but it cannot start?
New machine:
1. Disconnect the oil pipe from the carburetor to see if the oil is flowing properly and increase the idle speed slightly.
2. If there is no problem with the oil, check to see if the spark plug is burning.
3. If there is oil and fire but still no ignition, check reverse and forward rotation. (Press in the direction of the handle to rotate forward)
4. Then check if the air door is closed normally.
5.? Check if the measured voltage is too high. The 60 volt protection voltage is 68 volts, and the 72 volt protection voltage is 80 volts.
6. The carburetor should be cleaned after leaving it too long. Before use, add 5 ml of engine oil and read the instructions carefully.
Old machine:
1. Unscrew the spark plug and determine if there is a fire and carbon deposits.
2. Wipe the spark plug and install it. Start the extension cord. If it still doesn't catch fire, remove the spark plug and see if there is any oil on the spark plug. Otherwise, clean it. the carburetor or replace it. After cleaning, blow with an air gun.
3. Open the air filter cover and check whether the air door switch is normal.
4. Return to factory for repair.
Since the cruising range of low-speed four-wheel electric vehicles is still relatively limited and cannot fully meet the daily travel needs of the public, if you want to increase its cruising range , you can install an extended autonomy. Increase its cruising autonomy, increase its range of activities, meet the needss daily travel of the public and go back and forth freely, without more difficulty due to the lack of power halfway.
The reasons why the gasoline generator cannot ignite are: insufficient fuel; insufficient battery voltage or voltage that is too low to allow the starter motor to provide sufficient speed and torque to start the engine, among other things; others, including a spark plug or ignition coil failure, which prevents the engine from firing properly. A gasoline generator is generally composed of a stator, rotor, end cover, bearing and other components. An engine is a machine that converts chemical energy into mechanical energy. The conversion process is actually a work cycle process of generating. kinetic energy by burning fuel in the cylinder to drive the engine. The movementt reciprocating piston in the engine cylinder causes the connecting rod connected to the piston and the crank connected to the connecting rod to perform a reciprocating circular motion around the center of the crankshaft. to produce power.
One million subsidies for car purchases