This wire is the oil alarm connection wire. When the gasoline engine oil is too weak or too sticky, this wire will be connected to ground, causing the high voltage box to short to ground and close. downward, thereby preventing the engine from operating under oil starvation conditions and causing the shaft to stick, etc.
Boxin accessories are for reference only
Why. Do gasoline generators often stall automatically during operation?
The reasons and solutions why gasoline generators automatically stall are as follows:
1. Solution: Refuel on time.
2. The oil line is blocked. Solution: Add a special fuel cleaner to the car's fuel.
3. Body temperature is too high. Solution: Check if there is a leak in the water tank connection pipe, then checkCheck if the coolant is sufficient. If there is no coolant available in the car, mineral water can be used instead, but new coolant must then be replaced.
4. The load is too great. Solution: Depending on the situation, reduce the active and reactive loads of the generator until the stator and rotor currents do not exceed the rated values.
Precautions before using a gasoline generator:
1. Check the fuel tank: Mainly to observe whether there is enough gasoline in the fuel tank.
2. Check the fuel valve and oil line: if there is an oil leak.
3. Check if the oil dipstick is between the upper and lower limits.
4. Check the quality of the oil: determine if it needs to be replaced.
5. Check if the starting battery voltage is higherre to 12 V and observe if the battery is damaged or leaking.
One million subsidies for car purchases
Why doesn't the gasoline generator turn off even after turning off the switch?
The gasoline generator often turns off automatically during operation. There are several reasons. First, there is no oil. Second, the oil circuit is blocked. Third, the body temperature is too high. These situations will cause the gasoline generator to automatically stall during operation.
If the machine is not very old or old, it is recommended to replace the spark plug and carburetor. If it is certain that the spark plug is not the fault, it is recommended that the oil supply line is not smooth and that it be cleaned or replaced.
Detailed information:
1. Drain all gasoline from the fuel tank and carburetor;
2. crankcase
3. Add new engine oil to the upper limit of the oil level on the oil dipstick
4. Close the choke and pull the starter handle to where resistance is felt;
5. Wipe the device clean and cover it with cardboard or a plastic cover to prevent dust.
Gasoline generator shut-off switch. When connected it is off and when disconnected it is in working position. You can use a multimeter to measure whether the switch is turned on and off correctly. You can also replace it with another Let's try the new switch. If the main switch fails to extinguish the flame, it means that the switch cannot be turned on normally. VYou can also use a wire to directly short the switch to see if the motor can stop.