The reason the Honda ec6500cx generator shuts down after a few minutes of generating electricity is that the piston in the fuel injection pump housing (i.e. the high oil pump pressure) has been worn out for a long time, and the pressure cannot be achieved, so it will stall. When the car is idling at high speed, the engine speed is fast, so there will be no fire extinguishing. When the idle speed is low, the engine speed is slow, the piston pressure in the fuel injection pump will not reach the injection pressure and the fuel injector will not atomize the diesel, it will stall SO.
Hello, there are several reasons for this. Firstly, there is no oil, secondly, the oil circuit is blocked, thirdly, the body temperature is too high, and fourthly, the load is too great. These situations will cause the gasoline generator to automatically stall.during operation.
It is recommended to replace the spark plug and carburetor. If it is certain that the spark plug is not the fault, it is recommended that the oil supply line is not slick and cleaned or replaced.
1. Carbon deposition in the engine: Carbon deposition will cause insufficient combustion of gasoline, causing the engine to stall. Carbon deposits in the engine have a significant impact on the car. The first is to reduce the engine power, which means that the power output is uneven and gradually attenuates. The second is to increase fuel consumption and increase the economic burden. Third, it is difficult to start the car when cold, that is, it is difficult to ignite and it is not easy to start the car. Finally, heavy carbon deposits in the combustion chamber can cause knocking in the engine.cylinders and make noise when starting. acceleration at low speed, damaging the piston and crankshaft, causing high engine temperature and serious consequences for the safety of the car. In addition, if the emissions exceed the standard, it will not only fail to pass the annual inspection, but also directly aggravate the damage caused by environmental pollution.
2. Under-load operation of the gearbox: Under-load operation of the gearbox will destroy the quality and friction characteristics of the gearbox oil, increase friction and wear, and at the same time cause noise (impurities or dirt). dirt) will also be generated inside the gearbox (such as the valve body), causing the gearbox to deform, shift, impact, slip, stall, abnormal noise , delay, high temperatureand an oil leak. If the problem is not resolved in time, the gearbox will be scrapped.